Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2006 Pontiac Solstice car and truck
repair procedures including Pontiac engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2006 Pontiac Solstice automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR 2006 Pontiac Solstice AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Pontiac Solstice cars and light trucks from 1990+.
Disc Brakes -> Saturn/GM Single Piston -> Brake System Bleed -> Bleed Sequence -> Manual -> Pressure
Vehicle: 2006 Pontiac Solstice 2.4 L4 GAS
Manual
Pressure bleeding is recommended for all hydraulic systems. However, if a pressure bleeder is unavailable, use the following procedure. Brake fluid damages painted surfaces. Immediately clean any spilled fluid.
- Remove vacuum reserve by pumping brakes several times with engine off.
- Fill master cylinder reservoir with clean brake fluid. Do not let reservoir fall below half full during bleeding procedure.
- If required, bleed master cylinder as follows:
- Loosen master cylinder forward brake line connection until fluid flows from reservoir, then tighten brake line.
- Have assistant t...
CLICK HERE TO GET FULL ACCESS TO 2006 Pontiac Solstice BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Pontiac Solstice AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Pontiac Solstice cars and light trucks from 1990+.
Disc Brakes -> Saturn/GM Single Piston -> Disc Brake Specifications -> Caliper Specifications
Vehicle: 2006 Pontiac Solstice 2.4 L4 GAS
CLICK HERE TO GET FULL ACCESS TO 2006 Pontiac Solstice BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Pontiac Solstice AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Pontiac Solstice cars and light trucks from 1990+.
Hydraulic Brake Systems -> Hydraulic Brake System Flush
Vehicle: 2006 Pontiac Solstice 2.4 L4 GAS
If brake fluid is old, rusty or contaminated or whenever new components are installed in hydraulic system, the system must be flushed. Bleed brakes...
CLICK HERE TO GET FULL ACCESS TO 2006 Pontiac Solstice BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Pontiac Solstice AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Pontiac Solstice cars and light trucks from 1990+.
Disc Brakes -> Saturn/GM Single Piston -> Brake Pad Service -> AURA, Cobalt, G5, ION, Solstice & SKY -> Front -> L-Series -> Rear
Vehicle: 2006 Pontiac Solstice 2.4 L4 GAS
AURA, Cobalt, G5, ION, Solstice & SKY
- Raise and support vehicle, then remove tire and wheel assemblies.
- Tighten suitable C-clamp until piston is compressed into caliper bore. Remove C-clamp.
- Remove brake caliper lower guide pin bolt.
- Pivot caliper upward and support aside using suitable wire.
- Remove brake pads from caliper, Fig. and .
- Reverse procedure to install, noting the following:
- Inspect brake components.
- Bleed brake system as outlined under .
L-Series
F...
CLICK HERE TO GET FULL ACCESS TO 2006 Pontiac Solstice BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Pontiac Solstice AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Pontiac Solstice cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service -> Assemble -> Aura, Bonneville, DTS, ION, LeSabre, Lucerne, Park Avenue, Solstice & SKY -> Aveo -> Corvette -> CTS -> Disassemble -> Except Aura, Aveo, Bonneville, Cobalt, Corvette, CTS, DTS, G5, ION, L-Series, LaCrosse, LeSabre, Lucerne, Park Avenue, Solstice, SKY, STS, Vibe & XLR -> L-Series -> LaCrosse, STS & XLR -> Master Cylinder Overhaul -> Vibe -> Wheel Cylinder Overhaul
Vehicle: 2006 Pontiac Solstice 2.4 L4 GAS
Master Cylinder Overhaul
Except Aura, Aveo, Bonneville, Cobalt, Corvette, CTS, DTS, G5, ION, L-Series, LaCrosse, LeSabre, Lucerne, Park Avenue, Solstice, SKY, STS, Vibe & XLR
Disassemble
Refer to Figs. and when performing the following procedures.
- Disconnect and plug hydraulic lines.
- Remove mounting nuts and master cylinder.
- Remove reservoir cover and diaphragm. Discard old brake fluid.
- Inspect cover and diaphragm.
- Remove fluid level switch.
- On models equipped with compact master cylinder,remove proportioning valve, Fig. .
- On all models, depress primary piston and remove lock ring.
- Plu...
CLICK HERE TO GET FULL ACCESS TO 2006 Pontiac Solstice BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2006 Pontiac Solstice AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2006 Pontiac Solstice cars and light trucks from 1990+.
Power Brake Units -> Adjustments -> AC-Delco Tandem Diaphragm Type -> Air Method -> Brake Pedal -> Gauge Method -> Pushrod -> Toyota/GM Single Diaphragm Type
Vehicle: 2006 Pontiac Solstice 2.4 L4 GAS
Brake Pedal
Toyota/GM Single Diaphragm Type
- With engine running and brake pedal in rest position, measure distance between face of pedal and floor mat.
- Distance should be 5.850-6.244 inches.
- If distance is not as specified, adjust pedal height as follows:
- Remove lefthand lower instrument panel trim section and air duct.
- Loosen stop lamp switch sufficiently to access pedal adjustment.
- Loosen locknut and rotate pedal pushrod as required to obtain specified pedal height. Tighten locknut.
- Adjust brake lamp switch position so plunger lightly contacts pedal stopper and brake lamps are off when pe...
CLICK HERE TO GET FULL ACCESS TO 2006 Pontiac Solstice BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
