Auto Parts Search
2007 Chevrolet Impala CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Chevrolet REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- Brake Service
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2007 Chevrolet Impala car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your Chevrolet Impala automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
Power Brake Units -> Troubleshooting -> Brakes Grab -> Hard Pedal/Brakes Inefficient -> Slow Or No Release
Vehicle: 2007 Chevrolet Impala LTZ 3.9 V6 GAS
Brakes Grab
- Contaminated, worn or faulty brake linings.
- Drum or brake rotor out-of-round.
- Faulty brake booster.
Hard Pedal/Brakes Inefficient
- Contaminated, glazed or faul...
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala BRAKE SERVICE PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
CV AXLE SHAFT, Replace
Vehicle: 2007 Chevrolet Impala LS 3.5 V6 FLEX
- Raise and support vehicle on a hoist.
- Remove tire and wheel assembly.
- Disconnect tie rod from knuckle.
- Insert a drift into rotor and against caliper in order to prevent rotor from turning.
- Remove wheel drive shaft nut.
- Remove stabilizer link.
- Be sure that wheel speed sensor wiring harness is repositioned away from ball joint after disconnecting electrical connector from sensor. Disconnect ele...
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
Description
Vehicle: 2007 Chevrolet Impala LS 3.5 V6 GAS
The TPMS (Tire Pressure Monitor System) warns the driver when a significant loss, or gain of tire pressure occurs in any of the four tires and allows the driver to display the individual tire pressures and the locations on the DIC (Driver Information Center) display.
When the vehicle is stationary, the sensor is inactive. When the vehicle is operated and as the vehicle speed increases, centrifugal force activates the sensors internal accelerometer causing the sensors to go into rolling mode. In the rolling mode, the sensors read tire pressure once every 30 second and transmit the rea...
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
Alternator, Replace
Vehicle: 2007 Chevrolet Impala SS 5.3 V8 GAS
- Disconnect battery ground cable.
- Remove engine cover.
- Remove fender brace from righthand side of engine compartment.
- Rotate drive belt tensioner clockwise using a suitable serpentine belt tension unloader tool.
- Remove drive belt.
- Disconnect alternator electrical...
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
Cabin Air Filter Service -> General Motors Corp./Saturn -> 2004-08 Grand Prix, 2005-09 LaCrosse & 2006-07 Monte Carlo & 2006-09 Impala
Vehicle: 2007 Chevrolet Impala LT 3.5 V6 GAS
Under normal operating conditions the cabin air filter should be replaced every 12 months or 15,000 miles or at Maintenance II as indicated on the DIC (Driver Information Center). In dusty areas change the cabin air filter more often.
- Place the windshield wipers in the up position by turning the ignition switch Off when the wipers reach the desired position.
- Open the hood.
- Lift the righthand side of the rear hood seal from the flange in the area of the righthand air inlet grill...
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
General Motors Corp./Saturn Cars -> Low Coolant Lamp ->
Vehicle: 2007 Chevrolet Impala LT 3.5 V6 GAS
This lamp should light when engine coolant level in the radiator drops below a predetermined le...
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
Radiator, Replace
Vehicle: 2007 Chevrolet Impala LTZ 3.9 V6 GAS
- Remove intake manifold cover.
- Remove lefthand inner fender brace.
- Remove air cleaner outlet duct from throttle body.
- Disconnect PCV tube from air inlet duct.
- Disconnect Mass Air Flow (MAF) sensor electrical connector.
- Remove upper air cleaner housing.
- Remove Powertrain Control Module (PCM) and harness from lower air cleaner housing. Do not disconnect connectors.
- Remove Transmission Control Module (TCM) and harness from lower air cleaner housing. Do not disconnect connectors.
- Loosen clamp and remove air cleaner outlet duct from air cleaner.
- Disconnect two rubber grommets on inner rail a...
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2007 Chevrolet Impala AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2007 Chevrolet Impala LS 3.9 V6 GAS
- Remove intake manifold cover.
- Remove mounting bolts and lefthand inner fender brace.
- Remove air cleaner outlet duct from throttle body.
- Disconnect PCV tube from air inlet duct.
- Disconnect Mass Air Flow (MAF) sensor electrical connector.
- Remove upper from lower air cleaner housing.
- Remove Powertrain Control Module (PCM) and harness from lower air cleaner housing....
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 2007 Chevrolet Impala AUTOMOBILES
Component location diagrams for most 2007 Chevrolet Impala cars and light trucks sold in the U.S. from 1990+.
 Tire Pressure Monitor Sensor Diagram for 2007 Chevrolet Impala SS 5.3 V8 GASComponents on diagram: |
 Body Components Diagram for 2007 Chevrolet Impala LT 3.9 V6 GASComponents on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 2007 Chevrolet Impala AUTOMOBILES
OEM drawn wiring diagrams for most 2007 Chevrolet Impala cars and light trucks sold in the U.S.
 2007 Chevrolet Impala LS 3.5 V6 GAS Wiring DiagramComponents on diagram: |
 2007 Chevrolet Impala LT 3.5 V6 FLEX Wiring DiagramComponents on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 2007 Chevrolet Impala AUTOMOBILES
OEM TSB listings for most 2007 Chevrolet Impala cars and light trucks sold in the U.S. from 1985+.
|
Document: Resistance in Steering with High Under hood Temperatures Vehicle: 2007 Chevrolet Impala LS 3.5 V6 FLEX Auto Systems: |
|
Document: Revised General Motors New Vehicle Tire Warranty Program Vehicle: 2007 Chevrolet Impala LS 3.5 V6 FLEX Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2007 Chevrolet Impala AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2007 Chevrolet Impala cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2007 Chevrolet Impala cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2007 Chevrolet Impala cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2007 Chevrolet Impala cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2007 Chevrolet Impala SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
| More parts |
