2007 Dodge Sprinter 3500 Brake Service (ONLINE REPAIR MANUALS)

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings. The wheel bearings should be inspected at this time and repacked if required.

Do not get any oil or grease on the linings. It is recommended that both front wheel sets be replaced whenever a respective pad is worn or damaged. Inspect and, if required, replace rear brake linings also.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of ...

Caravan & Town & Country

Park Brake Shoes

• Set parking brake. Parking brake is set to keep hub/bearing and axle shaft from rotating when loosening hub nut.
• Raise and support vehicle allowing rear suspension to hang free.
• Remove rear wheels.
• Remove cotter pin and nut retainer from stub shaft of outer C/V joint.
• Remove spring washer, hub nut and washer from stub shaft of outer C/V joint.
• Release parking brake.
• Create slack in rear park brake by locking out automatic adjuster as follows:
• Grasp exposed section of front park brake and pull downward on it.
• Install a pair of suitable lockin...

Pedal Falls Away

• System leak at brake line, fitting, hose or caliper/wheel cylinder.
• Internal leakage in master cylinder caused by worn or damaged piston cups.
• Internal leak in ABS or RWAL system.

Low Pedal

• Worn brake linings.
• Worn drums or rotors.
• Rear brakes out of adjustment.

Spongy Pedal

• Air in hydraulic system.
• Thin brake drums.
• Substandard brake lines and hoses.

Hard Pedal Or High Pedal Effort

• Linings that are water soaked, contaminated or glazed.
• Faulty power booster or check valve.

Pedal Pulsation

• Disc brake rotors have excessive lateral runout or thickness variation.
• Out of round brake ...

Master Cylinder

Except Caravan & Town & Country

• With engine off, pump brake pedal five times to deplete vacuum in brake booster.
• Siphon fluid from brake reservoir.
• On Wrangler models, remove evaporative canister.
• On PT Cruiser models, remove air cleaner housing, then disconnect power distribution center and position aside.
• On all models, disconnect low fluid switch electrical connector.
• Remove brake lines from master cylinder.
• Remove master cylinder mounting nuts.
• On Durango models with ESP, remove inner fender well, then remove integrated power module (IPM) fasteners and move IPM ...

General Service Precautions

Certain components of the anti-lock brake system are not intended to be serviced individually. Attempting to remove or disconnect components of this type may result in personal injury and/or improper system operation. Only the components with removal and installation procedures should be serviced.

Observe the following general precautions when servicing the anti-lock b...

Caravan & Town & Country

Refer to for caliper replacement procedures.

Disassemble

• Remove caliper from adapter and rotor as outlined under . Do not disconnect brake hose from caliper. Support caliper at all times to prevent brake hose damage.
• Position caliper away from rotor to prevent brake fluid spillage on machined surface, then place a small block of wood between caliper fingers to prevent piston damage during removal.
• Gently depress brake pedal to force caliper piston out of bore, then secure brake pedal at any position below one inch of pedal travel to prevent master cylinder br...