2008 Chevrolet Silverado 1500 Brake Service (ONLINE REPAIR MANUALS)

General System

• Inspect components for damage or unusual wear. Replace as required.
• Inspect backing plate mounting bolts and ensure they are tight.
• Inspect wheel cylinders. Excessive fluid indicates cup leakage and need for wheel cylinder replacement. Slight amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
• Inspect adjuster screw operation. If satisfactory, lightly lubricate adjusting screw and washer with suitable brake lube. If operation is unsatisfactory, replace.
• Clean rust and dirt from shoe contact surfaces on backing plate using fi...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...

• Raise and support vehicle, then remove wheel and tire assemblies.
• Compress caliper pistons until they bottom in bores using suitable clamp.
• Remove calip...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is required. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort required to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (us...

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level because of a chemical breakdown during use and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessiv...

Master Cylinder

• On models equipped with manual brake system,disconnect master cylinder pushrod from brake pedal.
• On all models, disconnect all wire con...