2008 Chevrolet Silverado 2500 HD Brake Service (ONLINE REPAIR MANUALS)

When working on or around brake assemblies, care must be taken to prevent breathing asbestos dust, as many manufacturers incorporate asbestos fibers in the production of brake linings. During routine service operations, the amount of asbestos dust from brake lining wear is at a low level because of a chemical breakdown during use and a few precautions will minimize exposure. Do not sand or grind brake linings unless suitable local exhaust ventilation equipment is used to prevent excessiv...

Removal

• Siphon ^2/3 of the brake fluid from master cylinder.
• Raise and support vehicle.
• Remove tire and wheel assembly.
• Compress caliper pistons until they bottom in bores using suitable clamp, Fig. .
• Disconnect brake hose at caliper by removing inlet fitting bolt.
• Remove mounting bolts and caliper.

Inspection

Should it become required to remove the caliper for installation of new components, clean components in denatured alcohol, wipe dry using lint-free cloths. Blow out drilled passages and holes using compressed air. Inspect dust boots for punctures or tears. If punctures or tears are...

The Bosch ABS/EBD/TCS/VSES system consists of the following vehicle performance enhancement systems: Anti-Lock Brake System (ABS); Bi-State Engine Mount (BSM); Electronic Brake Distribution (EBD); Traction Control System (TCS); Variable Effort Steering (VES); Vehicle Stability Enhancement System (VSES). The Electronic Brake Control Module (EBCM) and the Brake Pressure Modulator Valve (BPMV) is serviced separately. The BPMV uses a 4 circuit configuration to control hydraulic pressure to each wheel independently.

When wheel slip is detected during a brake application, the ABS enters an...

General System

• Inspect components for damage or unusual wear. Replace as required.
• Inspect backing plate mounting bolts and ensure they are tight.
• Inspect wheel cylinders. Excessive fluid indicates cup leakage and need for wheel cylinder replacement. Slight amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
• Inspect adjuster screw operation. If satisfactory, lightly lubricate adjusting screw and washer with suitable brake lube. If operation is unsatisfactory, replace.
• Clean rust and dirt from shoe contact surfaces on backing plate using fi...

Excessive Pedal Travel

• Worn brake linings.
• Disc pads knock back after cornering or rough road travel.
• Piston and linings not properly seated or positioned.
• Insufficient fluid in system.
• Loose wheel bearing adjustment.
• Damaged or worn caliper piston seal.
• Improper booster pushrod adjustment.
• Pads out of flat more than .005 inch.
• Rear brake automatic adjusters inoperative.
• Improperly ground rear brake shoes.

Brake Roughness Or Chatter; Pedal Pumping

• Excessive lateral runout of rotor.
• Rotor excessively out of parallel.

Excessive Pedal Effort

• Frozen or seized pistons.
• Brake fluid, oil or grease on ...

Removal

• Siphon ^2/3 of the brake fluid from master cylinder.
• Raise and support vehicle.
• Remove tire and wheel assembly.
• Compress caliper pistons until they bottom in bores using suitable clamp, Fig. .
• Disconnect brake hose at caliper by removing inlet fitting bolt.
• Remove mounting bolts and caliper.

Inspection

Should it become required to remove the caliper for installation of new components, clean components in denatured alcohol, wipe dry using lint-free cloths. Blow out drilled passages and holes using compressed air. Inspect dust boots for punctures or tears. If punctures or tears are...