Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2008 KIA Optima car and truck
repair procedures including KIA engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2008 KIA Optima automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2008 KIA Optima
- 2008 KIA Optima LX 2.4 L4 GAS, CC:2359, Fuel Injection, Engine VIN:, Desg:3
- 2008 KIA Optima LX 2.7 V6 GAS, CC:2656, Fuel Injection, Engine VIN:, Desg:4
- 2008 KIA Optima EX 2.4 L4 GAS, CC:2359, Fuel Injection, Engine VIN:, Desg:3
- 2008 KIA Optima EX 2.7 V6 GAS, CC:2656, Fuel Injection, Engine VIN:, Desg:4
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 KIA Optima AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 KIA Optima cars and light trucks sold in the U.S. from 1990+.
Kia -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2008 KIA Optima EX 2.4 L4 GAS
The MIL will be illuminated when the ignition switch is in the On position and the engine is not running. When the engine is started, the lamp should go off. If it remains lit, a diagnostic trouble code has been stored.On models less OBD II, after diagnosis and repair are complete, place ignition switch in off position, then clear stored diagnostic trouble codes by disconnecting the battery ground cable for at least 20 seconds. On models equipped with OBD II, following diagnosis and repair of the system, the lamp may be turned off using a suita...
CLICK HERE TO GET FULL ACCESS TO 2008 KIA Optima MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 KIA Optima AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 KIA Optima cars and light trucks sold in the U.S. from 1990+.
Kia -> Electronic Stability Control (ESC)/Electronic Stability Program (ESP) Off Warning Lamp -> 2006-09 Optima
Vehicle: 2008 KIA Optima LX 2.4 L4 GAS
The ESC/ESP warning lamp will be illuminated for 3 seconds when the ignition switch is placed in the on position but should go out when the self-diagnostic system determines that the system is functioning properly. The lamp will illuminate when the ESC/ESP is switched off by de...
CLICK HERE TO GET FULL ACCESS TO 2008 KIA Optima MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 KIA Optima AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 KIA Optima cars and light trucks sold in the U.S. from 1990+.
Kia -> Tire Pressure Monitoring System (System) Warning Indicator -> 2006-09 Optima -> Relearn -> Reset -> Tire Pressure Sensor Initiation -> TPMS Receiver
Vehicle: 2008 KIA Optima EX 2.7 V6 GAS
Reset
The Low Tire Pressure Warning lamp will illuminate for approximately three seconds as a bulb check when the ignition switch is placed in the On position. This system uses radio frequency pressure sensors which monitor pressure in all 4 tires. When operating the vehicle at a speed above 20 mph the Low Tire Pressure Warning Lamp will illuminate when low tire pressure has been detected. Adjusting tires to correct pressure will turn lamp off.
Relearn
Tire Pressure Sensor Initiation
- Using Kia TPMS exciter tool, or equivalent, read the four tire pressure sensor IDs starting with sens...
CLICK HERE TO GET FULL ACCESS TO 2008 KIA Optima MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 KIA Optima AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 KIA Optima cars and light trucks sold in the U.S. from 1990+.
Kia -> Electronic Stability Control (ESC)/Electronic Stability Program (ESP) Indicator Lamp -> 2006-09 Optima
Vehicle: 2008 KIA Optima LX 2.7 V6 GAS
The ESC/ESP warning lamp will be illuminated for 3 seconds when the ignition switch is placed in the on position but should go out when the self-diagnostic system determines that the system is functioning properly. The lamp will also blink when the vehicle is operating under slippe...
CLICK HERE TO GET FULL ACCESS TO 2008 KIA Optima MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 KIA Optima AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 KIA Optima cars and light trucks sold in the U.S. from 1990+.
Kia -> Tire Pressure Monitoring System (System) Warning Indicator -> 2006-09 Optima -> Relearn -> Reset -> Tire Pressure Sensor Initiation -> TPMS Receiver
Vehicle: 2008 KIA Optima LX 2.4 L4 GAS
Reset
The Low Tire Pressure Warning lamp will illuminate for approximately three seconds as a bulb check when the ignition switch is placed in the On position. This system uses radio frequency pressure sensors which monitor pressure in all 4 tires. When operating the vehicle at a speed above 20 mph the Low Tire Pressure Warning Lamp will illuminate when low tire pressure has been detected. Adjusting tires to correct pressure will turn lamp off.
Relearn
Tire Pressure Sensor Initiation
- Using Kia TPMS exciter tool, or equivalent, read the four tire pressure sensor IDs starting with sens...
CLICK HERE TO GET FULL ACCESS TO 2008 KIA Optima MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 KIA Optima AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 KIA Optima cars and light trucks sold in the U.S. from 1990+.
Kia -> Electronic Stability Control (ESC)/Electronic Stability Program (ESP) Off Warning Lamp -> 2006-09 Optima
Vehicle: 2008 KIA Optima LX 2.7 V6 GAS
The ESC/ESP warning lamp will be illuminated for 3 seconds when the ignition switch is placed in the on position but should go out when the self-diagnostic system determines that the system is functioning properly. The lamp will illuminate when the ESC/ESP is switched off by de...
CLICK HERE TO GET FULL ACCESS TO 2008 KIA Optima MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2008 KIA Optima vehicle.
|
| Access the Complete guide! |
