Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2008 Scion XD car and truck
repair procedures including Scion engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2008 Scion XD automobile. Try the Automotix DIY solution today!
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2008 Scion XD AUTOMOBILES
Description, component locations, reset procedures, relearn procedures, diagnosis and testing, wiring diagrams, component replacement, and identification of vehicles equipped and not equipped with tire pressure monitoring system for most domestic and imported 2008 Scion XD cars and light trucks sold in the U.S. from mid 1990's+.
Component Locations
Vehicle: 2008 Scion XD 1.8 L4 GAS
Refer to F...
CLICK HERE TO GET FULL ACCESS TO 2008 Scion XD TIRE PRESSURE MONITORING SYSTEM PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2008 Scion XD AUTOMOBILES
Description, component locations, reset procedures, relearn procedures, diagnosis and testing, wiring diagrams, component replacement, and identification of vehicles equipped and not equipped with tire pressure monitoring system for most domestic and imported 2008 Scion XD cars and light trucks sold in the U.S. from mid 1990's+.
Reset Procedures
Vehicle: 2008 Scion XD 1.8 L4 GAS
The warning lamp will illuminate when tire pressure falls below a specified psi. When the warning lamp illuminates, check the air...
CLICK HERE TO GET FULL ACCESS TO 2008 Scion XD TIRE PRESSURE MONITORING SYSTEM PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2008 Scion XD AUTOMOBILES
Description, component locations, reset procedures, relearn procedures, diagnosis and testing, wiring diagrams, component replacement, and identification of vehicles equipped and not equipped with tire pressure monitoring system for most domestic and imported 2008 Scion XD cars and light trucks sold in the U.S. from mid 1990's+.
Description
Vehicle: 2008 Scion XD 1.8 L4 GAS
A tire pressure sensor and transmitter assembly is installed in each tire and wheel assembly, Fig. . The sensor measures the tire pressure. The measured tire pressure and transmitter identification are transmitted as radio waves to the TPMS (Tire Pressure Monitor System) warning antenna and receiver on the body. From the receiver the signal is sent to the TPMS ECU (Electronic C...
CLICK HERE TO GET FULL ACCESS TO 2008 Scion XD TIRE PRESSURE MONITORING SYSTEM PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2008 Scion XD AUTOMOBILES
Description, component locations, reset procedures, relearn procedures, diagnosis and testing, wiring diagrams, component replacement, and identification of vehicles equipped and not equipped with tire pressure monitoring system for most domestic and imported 2008 Scion XD cars and light trucks sold in the U.S. from mid 1990's+.
Diagnosis & Testing -> Accessing Diagnostic Trouble Codes -> Clearing DTCs (Diagnostic Trouble Codes) -> Diagnostic Trouble Code Identification -> Reset Switch Test -> Using Scan Tool -> Using TPMS Warning Lamp
Vehicle: 2008 Scion XD 1.8 L4 GAS
Accessing Diagnostic Trouble Codes
Using TPMS Warning Lamp
- Place the ignition switch in the Off position.
- Using Toyota SST or other suitable jumper, connect terminals TC and CG of DLC3. The DLC3 is located under the left side of the instrument panel, Fig. .
- Place the ignition switch in the On position.
- Read and note DTCs indicated by flashes of the TPMS warning lamp, Fig. .
- If the TPMS warning lamp blinks in .25 second intervals, a normal condition is indicated, Fig. .
- If the TPMS warning lamp blinks in .5 second intervals followed by a 1.5 second pause, then additional .5 second i...
CLICK HERE TO GET FULL ACCESS TO 2008 Scion XD TIRE PRESSURE MONITORING SYSTEM PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2008 Scion XD AUTOMOBILES
Description, component locations, reset procedures, relearn procedures, diagnosis and testing, wiring diagrams, component replacement, and identification of vehicles equipped and not equipped with tire pressure monitoring system for most domestic and imported 2008 Scion XD cars and light trucks sold in the U.S. from mid 1990's+.
Component Replacement -> Installation -> Removal -> Reset Switch -> Tire Pressure Sensor -> TPMS ECU -> TPMS Receiver
Vehicle: 2008 Scion XD 1.8 L4 GAS
TPMS Receiver
Removal
- Disconnect the battery ground cable.
- Remove the LH rear seat No. 1 and No. 2 leg covers, Fig. .
- Remove the LH rear seat retaining bolts, then the seat.
- Remove the deck board assembly.
- Remove the rear deck trim cover, Fig. .
- Remove the LH rear door scuff plate.
- Remove the LH rear door weather strip.
- Remove the luggage belt holder retaining screw, then the holder.
- Remove the LH deck trim side board retaining.
- Remove the LH seat belt anchor bolt, the roof side garnish panel.
- Disconnect the tire pressure warning receiver electrical connector, then remove the attachin...
CLICK HERE TO GET FULL ACCESS TO 2008 Scion XD TIRE PRESSURE MONITORING SYSTEM PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2008 Scion XD AUTOMOBILES
Description, component locations, reset procedures, relearn procedures, diagnosis and testing, wiring diagrams, component replacement, and identification of vehicles equipped and not equipped with tire pressure monitoring system for most domestic and imported 2008 Scion XD cars and light trucks sold in the U.S. from mid 1990's+.
Relearn Procedures -> Initialization -> Registration -> System Initialization -> Tire Pressure Sensor & Transmitter -> TPMS ECU
Vehicle: 2008 Scion XD 1.8 L4 GAS
Registration
TPMS ECU
If replacing the TPMS ECU, prior to removal, use a suitably programmed scan tool to read the registered transmitter identification number for all wheels and note them for registration.
- Connect a suitably programmed scan tool to DLC3 located under the LH side of the instrument panel.
- Using the scan tool, note the registered transmitter IDs that are stored in the old TPMS ECU.
- If reading the stored transmitter IDs from the old TPMS ECU is not possible, the tires will need to be removed from the wheels to read and note the tire pressure sensor transmitter IDs.
- Wi...
CLICK HERE TO GET FULL ACCESS TO 2008 Scion XD TIRE PRESSURE MONITORING SYSTEM PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2008 Scion XD vehicle.
|
| Access the Complete guide! |
