Auto Parts Search
We have info for following modifications of 2008 Toyota Prius
- 2008 Toyota Prius 1.5 L4 ELECTRIC/GAS, CC:1497, Fuel Injection
- 2008 Toyota Prius Touring 1.5 L4 ELECTRIC/GAS, CC:1497, Fuel Injection
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Prius AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Prius cars and light trucks sold in the U.S. from 1990+.
Toyota -> Automatic Transmission Overdrive Lamp ->
Vehicle: 2008 Toyota Prius Touring 1.5 L4 ELECTRIC/GAS
The "OD Off" lamp will be illuminated when the ignition switch is in the On position and the Overdrive (OD) switch is in the Off position. When the OD switch is placed in the On position, the "OD Off" lamp should go out. If the lamp flashes when the switch is placed in the On position, a fault has been detected by the electronic control system. After diagnosis and repair are c...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Prius MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Prius AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Prius cars and light trucks sold in the U.S. from 1990+.
Toyota -> Engine Oil Reminder/Maintenance Required Lamp -> 2004-09 Prius
Vehicle: 2008 Toyota Prius 1.5 L4 ELECTRIC/GAS
To reset Oil Replacement Reminder light, turn the power switch IG-ON and ensure that the ODO/TRIP meter is the odometer display. Turn the power switch Off. While pushing the ODO/TRIP meter switching & TRIP meter reset switch, turn power switch IG-ON. Until the resetting is comple...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Prius MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Prius AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Prius cars and light trucks sold in the U.S. from 1990+.
Toyota -> Air Bag Warning Lamp -> 2004-09 Prius
Vehicle: 2008 Toyota Prius 1.5 L4 ELECTRIC/GAS
- Connect two service wires to terminals Tc and CG of data link connector.
- Turn ignition switch to On position and wait for approximately 6 seconds.
- SRS warning lamps will illuminate 2-4 seconds later. Within 1-5 seconds, ground terminal Tc of DLC.
- SRS warning lamp will go off within 2-4 seconds. Within 1-5 seconds, release ...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Prius MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Prius AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Prius cars and light trucks sold in the U.S. from 1990+.
Toyota -> Anti-Lock Brake System (ABS)/Vehicle Stability Control (VSC) System Warning Lamp -> 2001-09 Prius
Vehicle: 2008 Toyota Prius 1.5 L4 ELECTRIC/GAS
The anti-lock warning lamp is used to warn of a system fault. The lamp will be lit during engine start-up, but should go out when the self-diagnostic system verifies proper anti-lock operation. If the lamp remains lit, a fault in the anti-lock brake system is indicated. After system diagnosis and repair are complete, the lamp can be reset using the following procedures:
- Place ignition switch i...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Prius MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Prius AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Prius cars and light trucks sold in the U.S. from 1990+.
Toyota -> Tire Pressure Warning Lamp -> 2006-09 Prius -> Registration -> Relearn -> Reset -> System Initialization -> Tire Pressure Sensor & Transmitter -> TPMS ECU
Vehicle: 2008 Toyota Prius 1.5 L4 ELECTRIC/GAS
Reset
This warning lamp will illuminate when tire pressure falls below a specified psi. When the warning lamp illuminates, check the air pressure of the tire and adjust it to specified pressure. When the vehicle is driven more than 18 mph after the adjustment, the lamp will go off.
Relearn
Registration
TPMS ECU
If replacing the TPMS ECU, prior to removal, use a suitably programmed scan tool to read the registered transmitter identification number for all wheels and note them for registration.
- Connect a suitably programmed scan tool to DLC3 located under the LH side of the instrument pan...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Prius MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Toyota Prius AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Toyota Prius cars and light trucks sold in the U.S. from 1990+.
Toyota -> Air Bag Warning Lamp -> 2004-09 Prius
Vehicle: 2008 Toyota Prius Touring 1.5 L4 ELECTRIC/GAS
- Connect two service wires to terminals Tc and CG of data link connector.
- Turn ignition switch to On position and wait for approximately 6 seconds.
- SRS warning lamps will illuminate 2-4 seconds later. Within 1-5 seconds, ground terminal Tc of DLC.
- SRS warning lamp will go off within 2-4 seconds. Within 1-5 seconds, release ...
CLICK HERE TO GET FULL ACCESS TO 2008 Toyota Prius MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2008 Toyota Prius vehicle. |
Access the Complete guide! |