Auto Parts Search

We have info for following modifications of 2009 Chevrolet Impala
- 2009 Chevrolet Impala LS 3.5 V6 FLEX, CC:3490, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:K
- 2009 Chevrolet Impala LS 3.5 V6 GAS, CC:3490, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:N
- 2009 Chevrolet Impala LS 3.9 V6 FLEX, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:M
- 2009 Chevrolet Impala SS 5.3 V8 GAS, CC:5328, CID:325, Fuel Injection, Aspiration:325, Engine VIN:, Desg:C
- 2009 Chevrolet Impala LT 3.5 V6 FLEX, CC:3490, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:K
- 2009 Chevrolet Impala LT 3.5 V6 GAS, CC:3490, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:N
- 2009 Chevrolet Impala LT 3.9 V6 FLEX, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:M
- 2009 Chevrolet Impala LTZ 3.9 V6 FLEX, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:M
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Impala cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Master Cylinder
Vehicle: 2009 Chevrolet Impala LT 3.5 V6 FLEX
Master Cylinder
- On Vibe models, remove air filter hose clamp and hose from throttle body.
- On all models, disconnect fluid level sensor retainer and electrical connector.
- Drain master cylinder reservoir brake fluid...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Impala cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Front Disc Brake -> Troubleshooting
Vehicle: 2009 Chevrolet Impala LTZ 3.9 V6 FLEX
The most common cause of brake chatter on disc brakes is a variation in disc thickness. If roughness or vibration is encountered during highway operation or if pedal pulsation is experienced at low speeds, the disc may have excessive thickness variation. To inspect for this condition, measure the disc at 12 points with a micrometer at a radius approximately one inch from edge of disc. If thickness me...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Impala cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Rear Disc Brake -> Tightening Specifications
Vehicle: 2009 Chevrolet Impala LS 3.5 V6 GAS
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Impala cars and light trucks from 1990+.
Power Brake Units -> Adjustments -> AC-Delco Tandem Diaphragm Type -> Air Method -> Brake Pedal -> Gauge Method -> GM/Toyota Single Diaphragm Type -> Pushrod
Vehicle: 2009 Chevrolet Impala LS 3.5 V6 GAS
Brake Pedal
GM/Toyota Single Diaphragm Type
- With engine running and brake pedal in rest position, measure distance between face of pedal and floor mat.
- Distance should be 5.850-6.244 inches.
- If distance is not as specified, adjust pedal height as follows:
- Remove lefthand lower instrument panel trim section and air duct.
- Loosen stop lamp switch sufficiently to access pedal adjustment.
- Loosen locknut and rotate pedal pushrod as required to obtain specified pedal height. Tighten locknut.
- Adjust brake lamp switch position so plunger lightly contacts pedal stopper and brake lamps are off when pe...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Impala cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Rear Disc Brake -> Adjustments -> Parking Brake
Vehicle: 2009 Chevrolet Impala LT 3.5 V6 GAS
Parking Brake
- Apply service brake with pedal force of 175 lbs., and release.
- Fully apply parking brake using approximately 125 lbs., of force on final stroke and release.
- Apply and release parking brake two additional times.
- Inspect parking brake pedal assembly for full release by turning ignition On and observing brake warning lamp. Lamp should be off.
- If brake warning lamp is on and parking brake appears to be fully released, operate manual pedal release lever and pull downward on front park brake cable to remove slack from pedal assembly.
- Raise and support vehicle.
- Inspect parking brake...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Impala BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Impala AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Impala cars and light trucks from 1990+.
Power Brake Units -> Troubleshooting -> Brakes Grab -> Brakes Inefficient/Hard Pedal -> Slow Or No Release
Vehicle: 2009 Chevrolet Impala LT 3.5 V6 GAS
Brakes Grab
- Contaminated, worn or faulty brake linings.
- Drum or brake rotor out-of-round.
- Faulty brake booster.
Brakes Inefficient/Hard Pedal
- Contaminated, glazed or faul...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Impala BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |