Auto Parts Search
2009 GMC Canyon CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT GMC REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2009 GMC Canyon car and truck
repair procedures including GMC engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your GMC Canyon automobile. Try the Automotix DIY solution today!
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 GMC Canyon AUTOMOBILES
DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 2009 GMC Canyon WT 3.7 L5 GAS
Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.
Disassemble
- Support propeller shaft in a line horizontal with table of a press.
- Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
- On models equipped with external snap ring retainers, proceed as follows:
- Disassemble snap rings by ...
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 GMC Canyon AUTOMOBILES
Diagnosis & Testing -> Accessing Diagnostic Trouble Codes -> Clearing Diagnostic Trouble Codes -> Diagnostic System Check -> Diagnostic Tests -> DTC C0750 Left Front Low Tire Pressure Sensor, C0755 Right Front Low Tire Pressure Sensor, C0760 Left Rear Low Tire Pressure Sensor Or C0765 Right Rear Low Tire Pressure Sensor -> DTC C0775 Low Tire Pressure System Sensors Not Learned -> Intermittent & Poor Connections -> Intermittents -> Low Tire Pressure Indicator Fault -> Poor Connections
Vehicle: 2009 GMC Canyon SLT 2.9 L4 GAS
Accessing Diagnostic Trouble Codes
Connect a suitably programmed scan tool to DLC (Data Link Connector) and follow manufacturer's instructions.
Diagnostic Tests
Low tire pressure in one or more tires is indicated by a continuously illuminated TPMS indicator after the bulb check is completed. The DIC will display a check tire pressure type message, if equipped. It is not necessary to perform the Relearn procedure for a low tire condition.
When a TPMS DTC is set, the TPMS indicator will flash for one minute after the bulb check is completed and then will remain illuminated. The DI...
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 GMC Canyon AUTOMOBILES
Alternator, Replace
Vehicle: 2009 GMC Canyon WT 2.9 L4 GAS
- Disconnect battery ground cable from battery.
- Remove accessory drive belt.
- Raise and support vehicle only high enough to access A/C compressor through wheelhouse.
- Remove left front wheel.
- Remove left wheelhouse liner.
- Disengage A/C compressor electrical connector from bracket. Evacuation of A/C refrigerant will not be necessary.
- Remove A/C compressor mounting bolts ONLY. Upper mounting bolt will remain with A/C compressor.
- Lower vehicle.
- Reposition protective boot from alternator output BAT terminal for access.
- Remove alternator ...
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon STARTER & ALTERNATOR REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 GMC Canyon AUTOMOBILES
General Motors Corp./Saturn Trucks -> Check Engine Oil Level ->
Vehicle: 2009 GMC Canyon SLE 3.7 L5 GAS
This system is used to indicate a low engine oil level condition. The lamp should light during engine starting. If oil level is sufficient, the lamp should go off when engine is operating. If oil level is low the...
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 GMC Canyon AUTOMOBILES
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 2009 GMC Canyon WT 2.9 L4 GAS
Lower
- Drain cooling system into a suitable container.
- Reposition hose clamp at radiator outlet and remove hose.
- Reposition hose clamp at thermostat housing and remove hose.
- Remove hose from vehicle.
- Reverse proc...
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 GMC Canyon AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 GMC Canyon SLT 2.9 L4 GAS
- Rotate tensioner clockwise, using suitable 3/8 inch breaker bar.
- Slide drive belt from water pump pul...
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 GMC Canyon AUTOMOBILES
OEM TSB listings for most 2009 GMC Canyon cars and light trucks sold in the U.S. from 1985+.
|
Document: Engine Rattle Noise after R And R of the Crankshaft Balancer -Inspect Bolt Torque Vehicle: 2009 GMC Canyon SLE 3.7 L5 GAS Symptoms: |
|
Document: Information on Driveline Clunk Noise When Shifting Between PARK and DRIVE, PARK and REVERSE or DRIVE and REVERSE Vehicle: 2009 GMC Canyon SLE 3.7 L5 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 GMC Canyon AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 GMC Canyon cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 GMC Canyon cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 GMC Canyon cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 GMC Canyon cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 GMC Canyon SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
| More parts |
