Auto Parts Search
2009 Land Rover Range Rover CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Land Rover REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Land Rover Range Rover AUTOMOBILES
DRIVESHAFT, Replace -> Front -> Rear
Vehicle: 2009 Land Rover Range Rover Supercharged 4.2 V8 GAS
Front
- Position vehicle on lift.
- Select NEUTRAL in the main gearbox.
- Raise vehicle on lift.
- Raise one front wheel to allow propeller shaft to rotate.
- Reference mark propeller shaft and differential to aid reassembly.
- Remove 6 nuts and bolts securing drive flange and propeller shaft to coupling. Discard locking nuts.
- Pull propeller shaft forwards and remove coupling and centering flange.
- Remove propeller shaft.
- Remove and discard O-ring from differential output drive tube.
- Reverse procedure to install, noting the following:
- Lubricate and install new O-ring.
- Align reference marks.
- Check and...
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Land Rover Range Rover AUTOMOBILES
Component Replacement -> Installation -> PM System Rear Antenna -> Removal -> Tire Pressure Sensor -> TPMS Front Antenna -> TPMS Module
Vehicle: 2009 Land Rover Range Rover Supercharged 4.2 V8 GAS
Tire Pressure Sensor
Removal
- Loosen the wheel lug nuts.
- Raise and support the vehicle with jack stands, then remove the wheel and tire assembly.
- Remove the tire valve cap and core and release the air from the tire.
- Separate the bead on the inside and outside of the tire, note the following:
- The bead breaker tool should not be used within 12 inch of the sensor valve in either direction.
- Position the shoe of the tool between 2 to 4 inches away from the sensor valve.
- The lever and tire must not come in contact with the sensor.
- Remove the tire pressure sensor nut, then the sensor, Fig....
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Land Rover Range Rover AUTOMOBILES
Starter, Replace
Vehicle: 2009 Land Rover Range Rover Supercharged 4.2 V8 GAS
- Disconnect battery ground cable.
- Raise and support vehicle. Do not work on or under a vehicle supported only by a jack. Always support vehicle on safety stands.
- Remove right front wheel.
- Remove bolts and engine undershield.
- Remove three upper suspension arm and brake line heat shield nuts, bolts, and shields.
- Remove terminal cover.
- Remove terminal insulator and nut from starter...
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Land Rover Range Rover AUTOMOBILES
Cabin Air Filter Service -> Land Rover -> 2002-09 Range Rover
Vehicle: 2009 Land Rover Range Rover HSE 4.4 V8 GAS
Under normal operating conditions the cabin air filter should be replaced every 12 months or 15,000 miles. In dusty areas change the cabin air filter more often.
- Open the hood.
- Remove the three plenum intake cover retaining screws, Fig. .
- Lift the fla...
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Land Rover Range Rover AUTOMOBILES
Land Rover -> Differential Lock Indicator Lamp ->
Vehicle: 2009 Land Rover Range Rover Supercharged 4.2 V8 GAS
The Differential Lock indicator lamp will illuminate when differential lock has been selected and will remain illuminated as long as the differential lock is engaged. When the differential lock is disengaged, the lamp should go Off after a short delay. If the lamp rem...
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Land Rover Range Rover AUTOMOBILES
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 2009 Land Rover Range Rover HSE 4.4 V8 GAS
Lower
- Drain coolant into a suitable container.
- Reposition hose clamp at radiator and remove hose.
- Reposition hose clamp at coolant outlet assembly and remove hose.
- Remove hose from vehicle.
- Reverse procedure ...
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Land Rover Range Rover AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Land Rover Range Rover Supercharged 4.2 V8 GAS
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove radiator splash shield.
- Rotate belt tensioner counterclockwise, us...
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Land Rover Range Rover AUTOMOBILES
OEM TSB listings for most 2009 Land Rover Range Rover cars and light trucks sold in the U.S. from 1985+.
Document: INFOTAINMENT SYSTEM LOCK-UP - REPAIR PROCEDURE - REVISED Vehicle: 2009 Land Rover Range Rover HSE 4.4 V8 GAS Symptoms: |
Document: NAVIGATION SYSTEM ROUTING ERRORS - REPAIR PROCEDURE Vehicle: 2009 Land Rover Range Rover HSE 4.4 V8 GAS Symptoms: |
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Land Rover Range Rover AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Land Rover Range Rover cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Land Rover Range Rover cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Land Rover Range Rover cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Land Rover Range Rover cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Land Rover Range Rover SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Land Rover Range Rover vehicle. |
Access the Complete guide! |