Auto Parts Search
2009 Mitsubishi Eclipse CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Mitsubishi REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Mitsubishi Eclipse AUTOMOBILES
CV AXLE SHAFT, Replace
Vehicle: 2009 Mitsubishi Eclipse Spyder GT 3.8 V6 GAS
Do not strike ABS rotors or outer race of driveshaft against other parts when removing or installing driveshaft. Use care not to strike pole piece at tip of front wheel speed sensor with tools when servicing vehicle.
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove front engine undercover bolts then undercover.
- Remove drain plug from transaxle and drain into suitable container.
- Remove wheel nuts and front wheels.
- Remove wheel hub cotter pin, nut, and washer. Do not apply pressure to wheel bearing from vehicle weight to avoid possible dama...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Mitsubishi Eclipse AUTOMOBILES
Reset Procedures -> Tire Pressure Sensor ID Registration -> Warning Lamp
Vehicle: 2009 Mitsubishi Eclipse GT 3.8 V6 GAS
Tire Pressure Sensor ID Registration
- Connect a suitable scan tool to vehicle data link connector, Fig. .
- Follow scan tool instructions to enter "Tire Pressure Sensor ID Registration" mode.
- Select the number of tires that you want to register.
- Starting at any TPMS transmitter, emit a signal from the transmitter as follows:
- Decrease the tire pressure to 25.2 psi or less by changing 2.9 psi or more, and register the TPMS transmitter ID code of each wheel to TPMS receiver
- Verify that a signal has...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Mitsubishi Eclipse AUTOMOBILES
Alternator, Replace
Vehicle: 2009 Mitsubishi Eclipse GS 2.4 L4 GAS
- Remove battery ground cable from battery.
- Remove side under cover.
- Remove drive belt.
- Remove harness bracket.
- Remove connector bracket.
- Remove alternator cover.
- Remove alternator connectors.
- Remove alternator mounting bolts...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse STARTER & ALTERNATOR REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Mitsubishi Eclipse AUTOMOBILES
Mitsubishi -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2008-09 Eclipse & Eclipse Spyder -> Relearn -> Reset -> Tire Pressure Sensor ID Registration -> Warning Lamp
Vehicle: 2009 Mitsubishi Eclipse GS 2.4 L4 GAS
Reset
Tire Pressure Sensor ID Registration
- Connect a suitable scan tool to vehicle data link connector, Fig. .
- Follow scan tool instructions to enter "Tire Pressure Sensor ID Registration" mode.
- Select the number of tires that you want to register.
- Starting at any TPMS transmitter, emit a signal from the transmitter as follows:
- Decrease the tire pressure to 25.2 psi or less by changing 2.9 psi or more, and register the TPMS transmitter ID code of each wheel to TPMS receiver
- Verify that a signal has been received by the TPMS rec...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Mitsubishi Eclipse AUTOMOBILES
Radiator, Replace
Vehicle: 2009 Mitsubishi Eclipse Spyder GS 2.4 L4 GAS
- Disconnect negative cable from battery.
- Drain coolant into a suitable container.
- Remove air cleaner.
- Remove overflow hose from radiator.
- Remove radiator upper hose.
- Remove radiator lower hose.
- Disconnect left and righthand cooling fan motor connectors.
- On models with automatic transaxle, remove two transaxle oil cooler hoses.
- On all m...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Mitsubishi Eclipse AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Mitsubishi Eclipse GT 3.8 V6 GAS
- Loosen tension pulley fixing nut.
- Loosen belt with adjusting bolt.
- Remove drive ...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Mitsubishi Eclipse AUTOMOBILES
OEM TSB listings for most 2009 Mitsubishi Eclipse cars and light trucks sold in the U.S. from 1985+.
Document: INSTALLATION PROCEDURE FOR LOOSE OR REPLACEMENT ROOF MOLDING Vehicle: 2009 Mitsubishi Eclipse GS 2.4 L4 GAS |
Document: RKE INTEGRATED KEY CASE SERVICE PARTS KIT AVAILABILITY Vehicle: 2009 Mitsubishi Eclipse GS 2.4 L4 GAS |
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Mitsubishi Eclipse AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Mitsubishi Eclipse cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Mitsubishi Eclipse cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Mitsubishi Eclipse cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Mitsubishi Eclipse cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Eclipse SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Mitsubishi Eclipse vehicle. |
Access the Complete guide! |