Auto Parts Search
2009 Nissan Maxima CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Nissan REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Nissan Maxima AUTOMOBILES
CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2009 Nissan Maxima SV 3.5 V6 GAS
Front
Before removing front axle assembly, remove wheel sensor from assembly. Move it away from front axle assembly area. Failure to follow these instructions may result in damage to sensor wires and wheel sensor becoming inoperative.
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front wheels.
- On models equipped with ABS, remove ABS wheel sensor. Note before removing front axle assembly, remove ABS wheel sensor from assembly, then position it aside. Failure to follow this instruction may result in damage to sensor or s...
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Nissan Maxima AUTOMOBILES
Relearn Procedures -> Activation -> ID Registration -> Less Activation Tool -> With Activation Tool
Vehicle: 2009 Nissan Maxima S 3.5 V6 GAS
Activation
The activation procedure must be performed after replacing or rotating tire and wheels, replacing tire pressure sensor or BCM.
- With Nissan sensor activation tool J-45295, or equivalent, pushed against the LF sensor, press and hold the activation tool button 5 seconds, Fig.
- With the ignition switch On, as the low tire pressure warning lamp blinks, Fig. , the respective sensor then must be initialized.
- Register the ID of tire pressure sensor that low tire pressure warning lamp blinks. When Activation of registered wheel has been completed, turn signal lamp blinks two ti...
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Nissan Maxima AUTOMOBILES
Starter, Replace
Vehicle: 2009 Nissan Maxima S 3.5 V6 GAS
- Disconnect battery ground and positive terminals.
- Remove air cleaner assembly and air ducts.
- Disconnect both ECM and TCM.
- Remove battery tray.
- Disconnect starter motor harness connectors.
- R...
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Nissan Maxima AUTOMOBILES
Cabin Air Filter Service -> Nissan -> 2009 Maxima & Murano
Vehicle: 2009 Nissan Maxima S 3.5 V6 GAS
Under normal operating conditions the cabin air filter should be replaced every 12 months or 15,000 miles. In dusty areas change the cabin air filter more often.
- Push up and pull out on the cabin air filter access cover tab to remov...
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Nissan Maxima AUTOMOBILES
Nissan -> Automatic Transmission (AT) Check Engine Lamp ->
Vehicle: 2009 Nissan Maxima SV 3.5 V6 GAS
The Automatic Transmission (AT) Check lamp will be illuminated for approximately 2 seconds when the ignition switch is placed in the on position as a bulb check and then go Off. If it remains lit or comes on at any other time, a malfunction in the a...
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Nissan Maxima AUTOMOBILES
Heater Hose, Replace -> Bypass -> Inlet -> Outlet
Vehicle: 2009 Nissan Maxima SV 3.5 V6 GAS
Inlet
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at heater core.
- Remove hose from heater core.
- Reposition hose clamp at water outlet.
- Remove hose from water outlet.
- Remove hose from vehicle.
- Reverse procedure to install.
Outlet
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at heat...
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Nissan Maxima AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Nissan Maxima SV 3.5 V6 GAS
- Rotate or lift the belt tensioner arm, using a suitable tool to relieve tension from dr...
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Nissan Maxima AUTOMOBILES
OEM TSB listings for most 2009 Nissan Maxima cars and light trucks sold in the U.S. from 1985+.
Document: A/C SYSTEM O-RING SEAL LEAKS Vehicle: 2009 Nissan Maxima S 3.5 V6 GAS Auto Systems: |
Document: SUNROOF DOES NOT OPERATE PROPERLY Vehicle: 2009 Nissan Maxima S 3.5 V6 GAS |
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Nissan Maxima AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Nissan Maxima cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Nissan Maxima cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Nissan Maxima cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Nissan Maxima cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Nissan Maxima SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Nissan Maxima vehicle. |
Access the Complete guide! |