2010 Lincoln MKT Driveline, U-Joint & CV Axles Replacement (ONLINE REPAIR MANUALS)

Auto Parts Search


Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2010 Lincoln MKT car and truck repair procedures including Lincoln engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 2010 Lincoln MKT automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

We have info for following modifications of 2010 Lincoln MKT

  • 2010 Lincoln MKT 3.7 V6 GAS, CC:3726, CID:227, Fuel Injection, Aspiration:227, Engine VIN:, Desg:R
  • 2010 Lincoln MKT Ecoboost 3.5 V6 GAS, CC:3496, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:T

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Lincoln MKT AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Lincoln MKT cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace
Vehicle: 2010 Lincoln MKT 3.7 V6 GAS

Do not reuse the bolts and cap straps for either the center U-joint or the rear U-joint. Install new bolts and cap straps or damage to the vehicle may occur. There is a difference in length of the head of the replacement yoke strap bolts from the production ...

CLICK HERE TO GET FULL ACCESS TO 2010 Lincoln MKT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Lincoln MKT AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Lincoln MKT cars and light trucks from 1990+.

DRIVESHAFT, Replace
Vehicle: 2010 Lincoln MKT 3.7 V6 GAS

Index-mark both driveshaft flanges.

  • With vehicle in NEUTRAL, position it on a hoist.
  • Remove muffler and tailpipe.
  • Remove exhaust support brace bolts and exhaust brace.
  • Remove and discard CV joint flange bolt and washer assemblies. Do not reuse the bolt and washer assemblies for the rear constant velocity (CV) joint flange. Install new assemblies or damage to the vehicle may occur.
  • Separate driveshaft CV flange from rear drive unit flange using a flat blade screwdriver.
  • Remove and discard driveshaft-to-transfer case bolts....

CLICK HERE TO GET FULL ACCESS TO 2010 Lincoln MKT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Lincoln MKT AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Lincoln MKT cars and light trucks from 1990+.

CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2010 Lincoln MKT Ecoboost 3.5 V6 GAS

Front

  • With vehicle in NEUTRAL, position it on a hoist.
  • Remove front tire and wheel assembly.
  • Remove and discard front wheel hub nut. Apply brake to keep halfshaft from rotating.
  • Remove ball joint nut and separate lower control arm from knuckle.
  • Separate halfshaft from wheel hub, using front wheel hub remover tool No. 205-D070 or equivalent.
  • For right front halfshaft, proceed as follows:
    • Remove bolt from brake tube bracket.
    • Remove lower scrivets from rubber shield and position shield aside.
  • For all halfshafts, pull knuckle outboard and rotate it toward rear of vehicle. Support knuc...

CLICK HERE TO GET FULL ACCESS TO 2010 Lincoln MKT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Lincoln MKT AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Lincoln MKT cars and light trucks from 1990+.

CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2010 Lincoln MKT 3.7 V6 GAS

Front

  • With vehicle in NEUTRAL, position it on a hoist.
  • Remove front tire and wheel assembly.
  • Remove and discard front wheel hub nut. Apply brake to keep halfshaft from rotating.
  • Remove ball joint nut and separate lower control arm from knuckle.
  • Separate halfshaft from wheel hub, using front wheel hub remover tool No. 205-D070 or equivalent.
  • For right front halfshaft, proceed as follows:
    • Remove bolt from brake tube bracket.
    • Remove lower scrivets from rubber shield and position shield aside.
  • For all halfshafts, pull knuckle outboard and rotate it toward rear of vehicle. Support knuc...

CLICK HERE TO GET FULL ACCESS TO 2010 Lincoln MKT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Lincoln MKT AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Lincoln MKT cars and light trucks from 1990+.

DRIVESHAFT, Replace
Vehicle: 2010 Lincoln MKT Ecoboost 3.5 V6 GAS

Index-mark both driveshaft flanges.

  • With vehicle in NEUTRAL, position it on a hoist.
  • Remove muffler and tailpipe.
  • Remove exhaust support brace bolts and exhaust brace.
  • Remove and discard CV joint flange bolt and washer assemblies. Do not reuse the bolt and washer assemblies for the rear constant velocity (CV) joint flange. Install new assemblies or damage to the vehicle may occur.
  • Separate driveshaft CV flange from rear drive unit flange using a flat blade screwdriver.
  • Remove and discard driveshaft-to-transfer case bolts....

CLICK HERE TO GET FULL ACCESS TO 2010 Lincoln MKT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2010 Lincoln MKT AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2010 Lincoln MKT cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace
Vehicle: 2010 Lincoln MKT Ecoboost 3.5 V6 GAS

Do not reuse the bolts and cap straps for either the center U-joint or the rear U-joint. Install new bolts and cap straps or damage to the vehicle may occur. There is a difference in length of the head of the replacement yoke strap bolts from the production ...

CLICK HERE TO GET FULL ACCESS TO 2010 Lincoln MKT DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2010 Lincoln MKT vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
Auto Repair Quick Search
Help me find