Auto Parts Search
Chevrolet Uplander CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Chevrolet REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Year
| 2009 | 2008 | 2007 | 2006 |
| 2005 |
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about Chevrolet Uplander car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your Chevrolet Uplander automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported Chevrolet Uplander cars and light trucks from 1990+.
Power Brake Units -> Delco Brake Booster -> Brake System Bleed -> Hydraulic System Flush -> Manual Bleed -> Master Cylinder Bleed -> Pressure Bleed
Vehicle: 2008 Chevrolet Uplander LS 3.9 V6 GAS
Manual Bleed
- If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
- Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
- If master cylinder is suspected to have air in bore, it must be bled first. To bleed master cylinder, proceed as follows:
- Disconnect forward brake pipe connection at master cylinder.
- Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
- Connect and ...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander BRAKE SERVICE PROCEDURES
FUEL FILTER REPLACEMENT PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Fuel filter replacement procedures with corresponding images for most domestic and imported Chevrolet Uplander cars and light trucks sold in the U.S. for 1980+.
General Motors Corp./Saturn Light Trucks, SUVs & Vans -> Fuel Filter Replacement -> Montana SV6, Relay, Terraza & Uplander
Vehicle: 2006 Chevrolet Uplander LS 3.5 V6 GAS
On models equipped with fuel injected engines, relieve fuel system pressure as outlined under "Fuel System Pressure Relief."
On models equipped with metal collar quick disconnect connectors, GM tool No. J37088-A, or equivalent, will be required to disconnect the connector. Prior to reconnecting the connector, apply a few drops of clean motor oil to the male pipe ends.
On models equipped with plastic collar quick disconnect connectors, squeeze the connector plastic retainer release tabs to release the connector. Prior to reconnecting the connector, apply a few ...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported Chevrolet Uplander cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2008 Chevrolet Uplander LS 3.9 V6 GAS
- Raise and support vehicle using a suitable lift.
- Reference mark propeller shaft at transfer case flange.
- Remove propeller shaft-to-transfer case flange bolts.
- Reference mark propeller shaft at torque tube flange.
- Remove propeller shaft-to-torque tube flange bol...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Description, component locations, reset procedures, relearn procedures, diagnosis and testing, wiring diagrams, component replacement, and identification of vehicles equipped and not equipped with tire pressure monitoring system for most domestic and imported Chevrolet Uplander cars and light trucks sold in the U.S. from mid 1990's+.
Component Replacement -> Installation -> Removal -> Tire Pressure Indicator Sensor
Vehicle: 2008 Chevrolet Uplander LS 3.9 V6 FLEX
Tire Pressure Indicator Sensor
Each tire pressure sensor has an internal power supply which has a service life of 10 years.
Removal
- Loosen the lug nuts.
- Raise and support vehicle with jack stands, then remove the wheel and tire assembly.
- Prior to dismounting the tire from the wheel, note the following precautions:
- Position the bead breaking fixture 90° from the valve stem when separating the tire bead from the wheel.
- Place the mounting and dismounting head so that the tire iron or pry bar can be inserted slightly clockwise of the sensor body when prying the tire bead up and over ...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Includes starter and alternator replacement procedures for domestic and imported Chevrolet Uplander cars and light trucks from 1990+.
Alternator, Replace
Vehicle: 2008 Chevrolet Uplander LT 3.9 V6 FLEX
- Disconnect battery ground cable.
- Remove cover from base of accessory wiring junction electrical center assembly.
- Remove positive battery cable nut and disconnect cable from positive terminal stud.
- Release locking tabs from base side of electrical center.
- Carefully lift at each side of underhood accessory wiring junction block to release from main body harness connectors, then move assembly aside.
- Remove right front underhood diagonal brace.
- Remove washer solvent container mounting bolts from fender flange and inner wheelhouse.
- Remove washer solvent container and move aside.
- Remove w...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Cabin air filter locations and replacement procedures with corresponding images for most domestic and imported Chevrolet Uplander cars and light trucks sold in the U.S. as equipped to the current model year.
Cabin Air Filter Service -> General Motors Corp./Saturn -> 2005-07 Montana SV6, Relay, Terraza & 2005-08 Uplander
Vehicle: 2007 Chevrolet Uplander LT 3.9 V6 FLEX
Under normal operating conditions the cabin air filter should be replaced every 15,000 miles or at Maintenance II as indicated on the DIC (Driver Information Center). In dusty areas change the cabin air filter more often.
- Open the glove compartment door.
- Remove the rear inside instrument panel compartment door.
- Open the cabin filter access door, Fig. .
- Remove the righthand cabin ...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported Chevrolet Uplander cars and light trucks sold in the U.S. from 1990+.
General Motors Corp./Saturn Trucks -> Service Four Wheel Drive (4WD) System Warning Lamp ->
Vehicle: 2007 Chevrolet Uplander LT 3.9 V6 FLEX
This lamp should light for approximately 6-8 seconds when the ignition is turned On as a bulb check. If the ...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Includes radiator, cooling and heater hose replacement procedures for domestic and imported Chevrolet Uplander cars and light trucks from 1990+
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 2007 Chevrolet Uplander 3.9 V6 FLEX
Lower
- Drain cooling system into a suitable container.
- Reposition hose clamp from thermostat housing using hose clamp pliers J 38185 or equivalent.
- Remove radiator outlet hose from thermostat housing.
- Remove air cleaner assembly.
- Reposition hose clamp from radiator using hose clamp pliers J 38185 or equivalent.
- Remove radiator outlet...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR Chevrolet Uplander AUTOMOBILES
Serpentine belt replacement procedures with corresponding images for most domestic and imported Chevrolet Uplander cars and light trucks sold in the U.S. from 1990+.
Serpentine Drive Belt, Replace
Vehicle: 2007 Chevrolet Uplander 3.9 V6 FLEX
- Rotate drive belt tensioner clockwise in order to relea...
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR Chevrolet Uplander AUTOMOBILES
Component location diagrams for most Chevrolet Uplander cars and light trucks sold in the U.S. from 1990+.
 Engine Electrical Components Diagram for 2007 Chevrolet Uplander LS 3.9 V6 FLEXComponents on diagram: |
 Driver Door Harness Components Diagram for 2008 Chevrolet Uplander 3.9 V6 GASComponents on diagram: |
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR Chevrolet Uplander AUTOMOBILES
OEM drawn wiring diagrams for most Chevrolet Uplander cars and light trucks sold in the U.S.
 2008 Chevrolet Uplander LT 3.9 V6 FLEX Wiring DiagramComponents on diagram: |
 2008 Chevrolet Uplander LS 3.9 V6 GAS Wiring DiagramComponents on diagram: |
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR Chevrolet Uplander AUTOMOBILES
OEM TSB listings for most Chevrolet Uplander cars and light trucks sold in the U.S. from 1985+.
|
Document: INFORMATION ON 4T65-E MN7, M15 AND M76 FRONT WHEEL DRIVE AUTOMATIC TRANSMISSION VALVE BODY RECONDITIONING, DTCS P0741, P0742, P0757, P0842, HARSH SHIFTS OR SLIPS - REVISED Vehicle: 2008 Chevrolet Uplander LS 3.9 V6 GAS Symptoms: |
|
Document: FUEL AND OIL ADDITIVES - FACTS AND MYTHS / MAXIMIZING FUEL ECONOMY - REVISED Vehicle: 2008 Chevrolet Uplander 3.9 V6 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR Chevrolet Uplander AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most Chevrolet Uplander cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most Chevrolet Uplander cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most Chevrolet Uplander cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most Chevrolet Uplander cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO Chevrolet Uplander SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
| More parts |
