1990 Chevrolet K2500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Diagnose power brakes systems as if two separate systems exist. Check for faults in the regular brake system first. If no problem exists in the regular brake system, diagnosis the power brake circuit is necessary. For a quick check of proper power unit operation, press the brake pedal firmly and then start the engine. The pedal should fall away slightly and less pressure should be needed to maintain the pedal in any position. On vacuum suspended power units, air will rush into the air intake when the brakes are applied.

To perform another check, remove the stop light switch, ...

BLEEDING EHCU MODULE

The EHCU Module should be bled after replacement or if trapped air is in the unit. If bleeding is required the module must be bled thoroughly before the wheel cylinders and calipers.

There are two bleeders on top of the unit that appear to be normal bleeders, Fig. . These are modulator bleeders and must remain closed when the unit is not pressurized.

The internal bleeders are on either side of EHCU module. The valves are used to open the internal passages within the EHCU module. Both bleed valves must be rotated ^1/4-^1/2 a turn counterclockwise before beginning t...

The procedures to remove & install the brake pads are outlined under "Caliper Service," "Remova... "

• Raise and support vehicle.
• Remove wheel, drum and brake shoes.
• Disconnect hydraulic line at wheel cylinder. Do not pull metal line away from cylinder, as this may kink or bend line. Line will separate from cylinder when cylinder is moved away from brake backing plate.
• Remove wheel cylinder-to-brake plate attaching screws, then the wheel cylinder.
• Remove boots, pistons, springs and cups from cylinder, Fig. .
• Clean all parts with brake fluid.
• Inspect cylinder bore. A scored bore may be honed as long as the diameter is not increased by ...

REMOVAL

• Siphon enough brake fluid out of the master cylinder to bring fluid level to^1-3 full to avoid fluid overflow when the caliper piston is pushed back into its bore.
• Raise and support vehicle, remove front wheels.
• Using a C-clamp, as illustrated in Fig. , push piston back into its bore.
• Remove two mounting bolts and lift caliper away from disc.

DISASSEMBLE

• Disconnect hose from the caliper being careful not to lose copper washers.
• Remove caliper as outlined above.
• Drain brake fluid from caliper.
• Pad caliper interior with clean shop towels and apply compressed air to remove piston, Fi...

DESCRIPTION

These power brake units, Figs. and , are a combination vacuum-hydraulic brake booster of the vacuum suspended type which use engine intake manifold vacuum and atmospheric pressure for its power.

These units consist of a vacuum power section and an hydraulic master cylinder section. The vacuum power section contains a power piston with rolling diaphragm mechanism and power piston return spring.

The control valve is made up of an air valve and floating vacuum control valve assembly. The reaction mechanism consists of an hydraulic piston, reaction plate and a series...