Auto Parts Search
1995 Ford E-150 Econoline CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Ford REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- A/C & Heater Service
- Brake Service
- Fuel Filter Replacement
- Driveline, U-Joint & CV Axles Replacement
- Starter & Alternator Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service

A/C & HEATER SERVICE PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
Component Replacement & Adjustment -> Light Duty Trucks & Vans -> HEATER CORE, REPLACE -> AEROSTAR -> Auxiliary -> Auxiliary Heater -> BRONCO & F-SERIES -> ECONOLINE -> EXPLORER & RANGER -> Standard -> Standard Heater -> VILLAGER -> WINDSTAR
Vehicle: 1995 Ford E-150 Econoline 5.0 V8 GAS
ECONOLINE
Standard
- Drain cooling system.
- Disconnect and plug inlet and outlet hoses from heater core.
- Remove screws retaining panel to underside of instrument panel, then the panel.
- Remove heater core cover attaching screws, Fig. , and the heater core cover.
- Remove screw and retaining bracket from bottom of heater core, then slide core and seal from case.
- Reverse procedure to install.
Auxiliary
- Drain cooling system.
- Remove rear bench seats, if equipped.
- Remove left center bolster trim pan...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline A/C & HEATER SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
Disc Brakes -> Precautions -> Aerostar, Explorer & Ranger -> Brake Bleeding -> Brake Disc Service -> Brake Linings -> Brake Roughness -> Caliper Inspection -> General Precautions
Vehicle: 1995 Ford E-150 Econoline Club Wagon 5.8 V8 GAS
Brake Linings
Remove both front wheels and inspect the brake discs, calipers and linings. (Wheel bearings should be inspected at this time and repacked if necessary).
Do not get any oil or grease on the linings. It is recommended that both front wheel sets be replaced whenever a respective shoe and lining is worn or damaged. Inspect and, if necessary, replace rear brake linings also.
If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.
Brake Roughness
The most common cause of brake chatter on disc brakes is a variation in thickness of ...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline BRAKE SERVICE PROCEDURES
FUEL FILTER REPLACEMENT PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
Ford Motor Co. Light Trucks, SUVs & Vans -> Fuel Pressure Relief -> Gasoline Fuel Injected Engines Except Escape, Freestar, Mariner, Monterey, Villager, 2005-06 Aviator, Explorer & Mountaineer, 2005-06 Expedition & Navigator & 2004-06 F150 & Mark LT
Vehicle: 1995 Ford E-150 Econoline 5.8 V8 GAS
The fuel system remains under high pressure even when the engine is not running. This residual pressure must be relieved before servicing the fuel system. To avoid injury or fire, release pressure from the fuel system before disconnecting any fuel line.
The fuel system pressure must be relieved prior to disconnecting fuel lines to prevent accidental spray of fuel.
After the battery ...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline FUEL FILTER REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble -> Single Cardan, Flange Yoke -> Single Cardan, Slip Yoke
Vehicle: 1995 Ford E-150 Econoline Club Wagon 5.0 V8 GAS
Single Cardan, Slip Yoke
Disassemble
Do not, under any circumstance, clamp the shaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing shaft failure during vehicle operation. Place the shaft on a suitable workbench. Do not damage the tube. If components are not marked and installed incorrectly, driveline imbalance can occur.
- Index-mark the shaft components.
- Remove and discard all four snap rings.
- Clamp bearing cup removal tool No. 205-086 or equivalent in a vise.
- If necessary, use a pair of pliers to remove a bearing cup t...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
Starter, Replace
Vehicle: 1995 Ford E-150 Econoline Club Wagon 4.9 L6 GAS
- Disconnect battery ground cable.
- Raise and support vehicle, if required.
- Disconnect electrical connector or solenoid relay wire from starter motor.
- Remove starter motor attach...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline STARTER & ALTERNATOR REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
Ford Motor Co. Trucks -> Air Bag Warning Lamp ->
Vehicle: 1995 Ford E-150 Econoline 5.8 V8 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the Air Bag warning ...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 1995 Ford E-150 Econoline Club Wagon 5.0 V8 GAS
Lower
- Drain cooling system into a suitable container.
- Reposition hose clamp from radiator.
- Remove radiator outlet hose from radiator.
- Reposition hose clamp from water pump connection.
- Remove radiator outlet hose from water pump connection and from vehicle.
- Reverse procedure...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 1995 Ford E-150 Econoline AUTOMOBILES
Serpentine Drive Belt, Replace -> Automatic Tension -> Manual Tension
Vehicle: 1995 Ford E-150 Econoline Club Wagon 4.9 L6 GAS
Automatic Tension
- Install suitable 5/16 inch closed end wrench on tensioner pulley bolt, then lift tensioner arm away from belt. Do not use socket and ratchet.
- Remove belt, slowly release tensioner. Do not allow tensioner to snap back, as damage may result.
- Reverse procedure to install.
Manual Tension
- Loosen accessory adjustment bolt and pivot bolt.
- Remove belt.
- Reverse procedure to install, adjust belt tension as follows:
- Lo...
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 1995 Ford E-150 Econoline AUTOMOBILES
Component location diagrams for most 1995 Ford E-150 Econoline cars and light trucks sold in the U.S. from 1990+.
![]() Components on diagram: |
![]() Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 1995 Ford E-150 Econoline AUTOMOBILES
OEM drawn wiring diagrams for most 1995 Ford E-150 Econoline cars and light trucks sold in the U.S.
![]() Components on diagram: |
![]() Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 1995 Ford E-150 Econoline AUTOMOBILES
OEM TSB listings for most 1995 Ford E-150 Econoline cars and light trucks sold in the U.S. from 1985+.
Document: SAFETY RECALL - SPEED CONTROL SYSTEM MODIFICATION Vehicle: 1995 Ford E-150 Econoline 5.0 V8 GAS Auto Systems: |
Document: RECALL - CERTAIN 1992-2003 MODEL YEAR CARS AND TRUCKS - FUSED JUMPER HARNESS REPLACEMENT FOR VEHICLES SERVICED WITH AN INCOMPATIBLE FUSED JUMPER HARNESS Vehicle: 1995 Ford E-150 Econoline 5.0 V8 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 1995 Ford E-150 Econoline AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 1995 Ford E-150 Econoline cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 1995 Ford E-150 Econoline cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 1995 Ford E-150 Econoline cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 1995 Ford E-150 Econoline cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 1995 Ford E-150 Econoline SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |