1997 Chevrolet S10 Pickup Brake Service (ONLINE REPAIR MANUALS)

This system is used on all models except Montana, Silhouette, Tracker, Trans Sport and Venture. On 2000 S & T Series , four door utility vehicles can be equipped with either a 310 or 325 ABS system. Pickups and two-door utility vehicles are equipped with 310 ABS systems. While both systems are functionally the same, the 310 differs in size and appearance from the 325. It is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHC...

Astro & Safari

• Apply parking brake.
• Disconnect reservoir and power steering hoses from booster.
• Remove master cylinder to brake booster retaining nuts.
• Position and support master cylinder away from booster. Do not remove hydraulic lines from master cylinder.
• Remove booster rod from top of brake pedal.
• Remove booster mounting nuts from inside of vehicle.
• Remove booster assembly and gasket.
• Reverse procedure to install, noting the following:
• Torque booster mounting nuts to 27 ft. lbs.
• Torque master cylinder retaining nuts to 27 ft. lbs.
• Torque power steering hoses to booster n...

General System

• Inspect components for damage or unusual wear. Replace as required.
• Inspect backing plate mounting bolts and ensure they are tight.
• Inspect wheel cylinders. Excessive fluid indicates cup leakage and need for wheel cylinder replacement. Slight amount of fluid is always present and is considered normal, acting as lubricant for cylinder pistons.
• Check adjuster screw operation. If satisfactory, lightly lubricate adjusting screw and washer with suitable brake lube. If operation is unsatisfactory, replace.
• C clean rust and dirt from shoe contact surfaces on backing plate using fi...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (...

G Series

• Remove brake pipes from master cylinder. Plug pipes to prevent fluid contamination.
• Remove master cylinder attaching nuts and position master cylinder aside.
• Disconnect stop lamp switch electrical connector.
• Remove stop lamp switch retainer from brake pedal pin, then the stop lamp switch from brake pedal support.
• Disconnect power brake unit pushrod from brake pedal.
• Remove attaching nuts, then the power brake unit.
• Reverse procedure to install.
• Torque booster retaining nuts to 27 ft. lbs.
• Torque master cylinder retaining nuts to 27 ft. lbs.
• Torque brake pipe fittings...