Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1997 Dodge Dakota car and truck
repair procedures including Dodge engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 1997 Dodge Dakota automobile. Try the Automotix DIY solution today!
We have info for following modifications of 1997 Dodge Dakota
- 1997 Dodge Dakota 3.9 V6 GAS, CID:239, Fuel Injection, Aspiration:239, Engine VIN:, Desg:X
- 1997 Dodge Dakota 5.2 V8 GAS, CID:318, Fuel Injection, Aspiration:318, Engine VIN:, Desg:Y
- 1997 Dodge Dakota 2.5 L4 GAS, CC:2507, CID:153, Fuel Injection, Aspiration:153, Engine VIN:, Desg:P
BRAKE SERVICE PROCEDURES FOR 1997 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Dodge Dakota cars and light trucks from 1990+.
Disc Brakes -> Dakota & Durango -> Brake Pad Service -> Installation -> Removal
Vehicle: 1997 Dodge Dakota 5.2 V8 GAS
Removal
- Clean master cylinder reservoir and filler caps, then remove caps and drain approximately 1/4 of fluid from reservoir using a suitable suction tool.
- Raise and support vehicle, then remove front wheel.
- Using a large c-clamp positioned over caliper body and outboard brake pad, bottom caliper piston by threading clamp screw inward upon outboard pad.
- Remove caliper slide pins, then the caliper with brake pads attached.
- Remove outboard brake pad by prying one end of retainer spring, Fig. , away from caliper, then tilt pad upward and rotate out of caliper.
- Remove inboard pad by ti...
CLICK HERE TO GET FULL ACCESS TO 1997 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Dodge Dakota cars and light trucks from 1990+.
Hydraulic Brake Systems -> Description -> Caravan, Town & Country & Voyager -> Combination Valve -> Except Caravan, Town & Country & Voyager -> Fixed Proportioning Valve -> Height Sensing Proportioning Valve -> Hydraulic Control Valves -> Master Cylinder -> Metering Valve
Vehicle: 1997 Dodge Dakota 5.2 V8 GAS
Master Cylinder
Except Caravan, Town & Country & Voyager
The cylinder body containing the primary and secondary pistons is made of aluminum. The removable fluid reservoir is made of nylon reinforced with glass fiber. The reservoir is the only serviceable component.
The fluid compartments of the nylon reservoir are interconnected to permit fluid level equalization. The equalization feature does not affect circuit separation in the event of a front or rear brake malfunction. The reservoir compartments will retain enough fluid to operate the functioning hydraulic circuit.
Caravan, Town & C...
CLICK HERE TO GET FULL ACCESS TO 1997 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Dodge Dakota cars and light trucks from 1990+.
Drum Brakes -> DaimlerChrysler -> Inspection -> Adjuster Mechanism -> Backing Plate -> Brake Drums -> Brake Linings & Springs -> Parking Brake Cable
Vehicle: 1997 Dodge Dakota 2.5 L4 GAS
Brake Drums
Any time the brake drums are removed for brake service, the braking surface diameter should be checked with a suitable brake drum micrometer at several points to determine if they are within the safe oversize limit stamped on the brake drum outer surface. If the braking surface diameter exceeds specifications, the drum must be replaced. If the braking surface diameter is within specifications, drums should be cleaned and inspected for cracks, scores, deep grooves, taper, out of round and heat spotting. If drums are cracked or heat spotted, they must be replaced. Minor scor...
CLICK HERE TO GET FULL ACCESS TO 1997 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Dodge Dakota cars and light trucks from 1990+.
Anti-lock Brakes -> Dakota, Durango, Full Size Pickup & Van -> Description -> Four Wheel Anti-Lock Brake (4 WABS) System -> RWAL System
Vehicle: 1997 Dodge Dakota 2.5 L4 GAS
RWAL System
The rear-wheel Anti-Lock Brake System (ABS) is standard equipment on all models. This system prevents rear wheel lock-up by monitoring wheel speed and altering pressure to the rear wheels. Rear brake fluid application is controlled according to wheel speed, degree of wheel slip and rate of deceleration. The main components of the system are an electronic brake control module, a hydraulic pressure control valve, a speed sensor and a sensor exciter ring, Fig. . A standard master cylinder and power booster are used.
Four ...
CLICK HERE TO GET FULL ACCESS TO 1997 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Dodge Dakota cars and light trucks from 1990+.
Disc Brakes -> Dakota & Durango -> Brake Pad Service -> Installation -> Removal
Vehicle: 1997 Dodge Dakota 3.9 V6 GAS
Removal
- Clean master cylinder reservoir and filler caps, then remove caps and drain approximately 1/4 of fluid from reservoir using a suitable suction tool.
- Raise and support vehicle, then remove front wheel.
- Using a large c-clamp positioned over caliper body and outboard brake pad, bottom caliper piston by threading clamp screw inward upon outboard pad.
- Remove caliper slide pins, then the caliper with brake pads attached.
- Remove outboard brake pad by prying one end of retainer spring, Fig. , away from caliper, then tilt pad upward and rotate out of caliper.
- Remove inboard pad by ti...
CLICK HERE TO GET FULL ACCESS TO 1997 Dodge Dakota BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1997 Dodge Dakota AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1997 Dodge Dakota cars and light trucks from 1990+.
Anti-lock Brakes -> Dakota, Durango, Full Size Pickup & Van -> Troubleshooting -> 4 WABS System -> Isolation & Dump Solenoid Inspection Procedures -> Main Relay Inspection Procedures -> Pump/Motor Circuit Open -> Pump/Motor Inspection Procedures -> Pump/Motor Stalled -> Relay Open -> Relay Shorted -> RWAL System -> Solenoid Open -> Solenoid Shorted
Vehicle: 1997 Dodge Dakota 3.9 V6 GAS
RWAL System
RWAL system malfunctions are indicated by a warning lamp on the instrument cluster. If such a malfunction occurs, proceed as follows:
- Inspect brake fluid level and correct as necessary.
- Visually inspect ABS hydraulic and electrical connections and correct as necessary.
- If hydraulic system leaks or weak or corroded electrical connections are not evident, road test vehicle to inspect vehicle for driveability conditions such as low or spongy pedal, brake pulling or grabbing.
- Ensure parking brake is operating properly and is fully released.
- If visual inspections and road test ...
CLICK HERE TO GET FULL ACCESS TO 1997 Dodge Dakota BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
