Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1997 Ford E Super Duty car and truck
repair procedures including Ford engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 1997 Ford E Super Duty automobile. Try the Automotix DIY solution today!
We have info for following modifications of 1997 Ford E Super Duty
- 1997 Ford E Super Duty 5.4 V8 GAS, CID:330, Fuel Injection, Aspiration:330, Engine VIN:, Desg:L
- 1997 Ford E Super Duty 7.3 V8 DIESEL, CID:445, Fuel Injection, Aspiration:445, Engine VIN:, Desg:F
- 1997 Ford E Super Duty 6.8 V10 GAS, CID:415, Fuel Injection, Aspiration:415, Engine VIN:, Desg:S
MAINTENANCE LAMP RESET PROCEDURES FOR 1997 Ford E Super Duty AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1997 Ford E Super Duty cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Diesel Engine Air Filter Restriction Warning System -> E-Series
Vehicle: 1997 Ford E Super Duty 7.3 V8 DIESEL
These models have an air filter restriction gauge located on the clean air side of the air cleaner upper housing. It has a colored indicator which alerts the operator ...
CLICK HERE TO GET FULL ACCESS TO 1997 Ford E Super Duty MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1997 Ford E Super Duty AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1997 Ford E Super Duty cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Low Oil Level Warning Indicator ->
Vehicle: 1997 Ford E Super Duty 5.4 V8 GAS
This system is used to indicate a low engine oil level condition. The lamp should light during engine starting. If oil level is sufficient, the lamp should go off when engine is operating. If oil level is low the...
CLICK HERE TO GET FULL ACCESS TO 1997 Ford E Super Duty MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1997 Ford E Super Duty AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1997 Ford E Super Duty cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Check Engine Lamp -> 1993-97 -> Continuous Memory -> EEC -> EEC IV -> EEC V -> Except Malfunction Indicator Lamp (MIL) -> Keep Alive Memory (KAM) -> Keep Alive Memory (KAM) Reset & PCM Reset Less Electronic Tester -> Malfunction Indicator Light -> PCM Reset Using Generic Scan Tool
Vehicle: 1997 Ford E Super Duty 6.8 V10 GAS
EEC
Except Malfunction Indicator Lamp (MIL)
When using NGS tool No. 007-00500, or equivalent, select Diagnostic Test Mode Results, then press CLEAR or disconnect battery ground cable. Codes will be erased from back-up memory after 24 hours.
Malfunction Indicator Light
- Activate diagnostic test mode.
- Disconnect diagnostic connector.
- Jump BL/W and GY/BL wires using suitable jumper wire.
- Wait about two seconds.
- Remove jumper wire and reconnect diagnostic connector.
- MIL will stay on, and codes will be erased.
EEC IV
Continuous Memory
This lamp should light when the ignition is turned On. After the engin...
CLICK HERE TO GET FULL ACCESS TO 1997 Ford E Super Duty MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1997 Ford E Super Duty AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1997 Ford E Super Duty cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Traction Control System Warning Lamp ->
Vehicle: 1997 Ford E Super Duty 6.8 V10 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the warni...
CLICK HERE TO GET FULL ACCESS TO 1997 Ford E Super Duty MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1997 Ford E Super Duty AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1997 Ford E Super Duty cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Diesel Engine Air Filter Restriction Warning System -> E-Series
Vehicle: 1997 Ford E Super Duty 6.8 V10 GAS
These models have an air filter restriction gauge located on the clean air side of the air cleaner upper housing. It has a colored indicator which alerts the operator ...
CLICK HERE TO GET FULL ACCESS TO 1997 Ford E Super Duty MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 1997 Ford E Super Duty AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 1997 Ford E Super Duty cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Check Gauge Warning Lamp ->
Vehicle: 1997 Ford E Super Duty 5.4 V8 GAS
This indicator should light if any of the following conditions appear:
- Engine oil pressure drops below approxi...
CLICK HERE TO GET FULL ACCESS TO 1997 Ford E Super Duty MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 1997 Ford E Super Duty vehicle.
|
| Access the Complete guide! |
