1997 GMC K1500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brakes will still operate, as the convention...

Brake System Bleed

Gravity and vacuum bleeding procedures are not recommended for use with the anti-lock brake system. The manual bleed procedure is the preferred method, although pressure bleeding is also possible. Do not pump the brake pedal during the bleeding process, as fluid aeration may occur.

Manual Bleed

• Raise and support vehicle, then connect a clear plastic tube to brake bleed screw at righthand rear wheel.
• Place free end of tube in a glass jar partially filled with clean brake fluid. Ensure end of tube remains submerged in fluid and master cylinder reservoir is kept full.
• ...

The power brake unit is n...

Removal

Front

• Siphon brake fluid out of master cylinder until fluid level is approximately ^1/3 full, this will prevent fluid overflow when caliper piston is pushed back into its bore.
• Raise and support vehicle, then remove wheels.
• Push piston back into its bore using suitable C-clamp, Fig. .
• Remove two caliper mounting bolts and lift caliper off of rotor.

Rear

Blazer, Bravada & Jimmy

• Raise and support vehicle.
• Mark position of wheel to hub for installation reference.
• Remove wheel assembly.
• Remove mounting bolt and disconnect brake hose fitting from caliper. Discard gaskets and plug brake h...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (...

This system is used on all models except Montana, Silhouette, Tracker, Trans Sport and Venture. On 2000 S & T Series , four door utility vehicles can be equipped with either a 310 or 325 ABS system. Pickups and two-door utility vehicles are equipped with 310 ABS systems. While both systems are functionally the same, the 310 differs in size and appearance from the 325. It is designed to reduce the occurrence of wheel lock-up during severe braking conditions. To accomplish this function, the system regulates hydraulic brake line pressure by using an Electro-Hydraulic Control Unit (EHC...