2000 Chevrolet Express 2500 Brake Service (ONLINE REPAIR MANUALS)

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect ...

Battery Ground Cable

Prior to service, dis...

Disassemble

• Place accumulator compressor tool No. J-26889, or equivalent, around end of accumulator.
• Install nut onto stud as shown in Fig. , then depress the accumulator with a C-clamp.
• Remove retainer by using a punch.
• Release C-clamp and remove accumulator compressor tool.
• Remove accumulator, O-ring, retainer, plug and spring, Fig. .
• Remove retainer, output pushrod, baffle, piston return spring and retainer.
• Using a suitable saw, cut off eyelet of pedal rod, then remove the boot.
• Remove nut, bracket and bolts, then separate cover from housing.
• Remove piston assembly and seal...

In order to properly service power brake systems, a thorough understanding of the various power assist systems is necessary. These systems provide a mechanical assist, acting to increase the force applied to the master cylinder piston by the driver while decreasing the effort necessary to obtain acceptable stopping performance. Two basic types of power assist mechanisms are used: vacuum assist diaphragm assemblies which use engine vacuum and in some cases vacuum from an external vacuum pump, and hydraulic assist assemblies which use hydraulic pressure developed by an external pump (...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brakes will still operate, as the convention...