2001 Chevrolet Express 1500 Brake Service (ONLINE REPAIR MANUALS)

C & K Series

Duo-Servo

Removal

• Raise and support vehicle.
• Mark relationship of wheel to hub, then remove tire and wheel assembly.
• On models equipped with full-floating axles, remove hub and drum assembly as described in "Drive Axles."
• On models equipped with semi-floating axles, proceed as follows:
• Install pin into park brake lever.
• Mark relationship of drum to axle.
• Remove rear brake drum retainers, as required.
• Remove rear brake drum.
• On all models, remove return springs and shoe guide, Fig. .
• Remove brake hold down springs and pins.
• Disconnect actuator lever and pivot.
• Remove lever return spri...

Brake Lines & Linings

Remove one of the front wheels and inspect the brake disc, caliper and linings.

Do not allow any oil or grease on the linings. It is recommended that linings be replaced in sets when worn or damaged.

If the caliper is cracked or fluid leakage through the casting is evident, it must be replaced as a unit.

Brake Roughness

The most common cause of brake chatter on disc brakes is a variation in thickness of the disc. If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness v...

Height Sensing Proportioning Valve

The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be checked if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.

• Raise and support vehicle, leave wheels on and allow axle to hang freely.
• Remove lever retaining nut and disconnect lever from valve shaft, Fig. .
• Rotate valve shaft to permit installation of correct adjustment gauge, Fig. , ensure D shaped ho...

Removal

Front

• Siphon brake fluid out of master cylinder until fluid level is approximately ^1/3 full, this will prevent fluid overflow when caliper piston is pushed back into its bore.
• Raise and support vehicle, then remove wheels.
• Push piston back into its bore using suitable C-clamp, Fig. .
• Remove two caliper mounting bolts and lift caliper off of rotor.

Rear

Blazer, Bravada & Jimmy

• Raise and support vehicle.
• Mark position of wheel to hub for installation reference.
• Remove wheel assembly.
• Remove mounting bolt and disconnect brake hose fitting from caliper. Discard gaskets and plug brake h...

Battery Ground Cable

Prior to service disconnect battery ground cable and isolate as required.

Radio Security System

Theftlock

If the Theftlock system is active when battery power is interrupted, the customers security code must be entered to restore proper function of the radio. To unlock a secured radio after power loss, proceed as follows:

• "LOC" appears with ignition in On position.
• Press "NM" and "000" will appear on display.
• Press "NM" again to make last two digits agree with security code.
• Press "HR" to make first 1 or 2 digits agree with security code.
• Press "AM-FM" to select code entered. "SEC" wi...

Brake System Bleed

Gravity and vacuum bleeding procedures are not recommended for use with the anti-lock brake system. The manual bleed procedure is the preferred method, although pressure bleeding is also possible. Do not pump the brake pedal during the bleeding process, as fluid aeration may occur.

Manual Bleed

• Raise and support vehicle, then connect a clear plastic tube to brake bleed screw at righthand rear wheel.
• Place free end of tube in a glass jar partially filled with clean brake fluid. Ensure end of tube remains submerged in fluid and master cylinder reservoir is kept full.
• ...