Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2002 Chevrolet Venture car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2002 Chevrolet Venture automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR 2002 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Chevrolet Venture cars and light trucks from 1990+.
Drum Brakes -> Brake Service -> Astro, Bravada, S & T Series & Safari -> Aztek, Rendezvous & Vue -> C & K Series -> Duo-Servo -> Express & Savana -> Installation -> Montana, Silhouette, Trans Sport & Venture -> P Series -> Removal -> Single-Servo -> Tracker
Vehicle: 2002 Chevrolet Venture 3.4 V6 GAS
C & K Series
Duo-Servo
Removal
- Raise and support vehicle.
- Mark relationship of wheel to hub, then remove tire and wheel assembly.
- On models equipped with full-floating axles, remove hub and drum assembly as outlined in. "Drive Axles."
- On models equipped with semi-floating axles, proceed as follows:
- Install pin into park brake lever.
- Mark relationship of drum to axle.
- Remove rear brake drum retainers, as required.
- Remove rear brake drum.
- On all models, remove return springs and shoe guide,. Fig. .
- Remove brake hold down springs and pins.
- Disconnect actuator lever and pivot.
- Remove lever return sp...
CLICK HERE TO GET FULL ACCESS TO 2002 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Chevrolet Venture cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service -> Assemble -> Bendix Master Cylinder -> Delco Master Cylinder -> Disassemble -> Tracker Master Cylinder -> Wheel Cylinder
Vehicle: 2002 Chevrolet Venture 3.4 V6 GAS
Delco Master Cylinder
When performing the following procedures, refer to. Figs. and , noting that the composite reservoir may vary in design.
Disassemble
- Remove master cylinder from vehicle.
- Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
- Inspect cover and diaphragm. Replace if cut, cracked or deformed.
- Remove fluid level switch and proportioning valve assembly, if equipped.
- Depress primary piston and remove lock ring.
- Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet...
CLICK HERE TO GET FULL ACCESS TO 2002 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Chevrolet Venture cars and light trucks from 1990+.
Disc Brakes -> Delco Single Piston Sliding Caliper -> Troubleshooting -> Brake Rattle -> Brake Roughness Or Chatter; Pedal Pumping -> Caliper Brake Fluid Leak -> Excessive Pedal Effort -> Excessive Pedal Travel -> Heavy Brake Drag -> No Braking Effect When Brake Pedal Is Depressed -> Pull, Uneven Or Grabbing Brakes -> Rear Brakes Locking On Application
Vehicle: 2002 Chevrolet Venture 3.4 V6 GAS
Excessive Pedal Travel
- Worn brake linings.
- Disc pads knock back after cornering or rough road travel.
- Piston and linings not properly seated or positioned.
- Insufficient fluid in system.
- Loose wheel bearing adjustment.
- Damaged or worn caliper piston seal.
- Improper booster pushrod adjustment.
- Pads out of flat more than .005 inch.
- Rear brake automatic adjusters inoperative.
- Improperly ground rear brake shoes.
Brake Roughness Or Chatter; Pedal Pumping
- Excessive lateral runout of rotor.
- Rotor excessively out of parallel.
Excessive Pedal Effort
- Frozen or seized pistons.
- Brake fluid, oil or grease on ...
CLICK HERE TO GET FULL ACCESS TO 2002 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Chevrolet Venture cars and light trucks from 1990+.
Anti-Lock Brakes -> Delphi 7.0 -> Diagnosis & Testing -> Accessing Diagnostic Trouble Codes -> Clearing Diagnostic Trouble Codes -> Connector Pin Identification -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> Intermittents & Poor Connections -> Symptom Tests -> Temperature Vs. Resistance
Vehicle: 2002 Chevrolet Venture 3.4 V6 GAS
Accessing Diagnostic Trouble Codes
Connect a suitably programmed scan tool to Data Link Connector (DLC) and follow manufacturers instructions.
Diagnostic Trouble Code Interpretation
[[table data]]Connector Pin Identification
Refer to Figs. through for connector pin identification.
Diagnostic Tests
[[table data]]Symptom Tests
[[table data]]Temperature Vs. Resistance
Refer to Fig. for temperature vs. resistance values.
Intermittents & Poor Connections
Most Intermittents are caused by faulty electrical connections or wiring, although a sticking r...
CLICK HERE TO GET FULL ACCESS TO 2002 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Chevrolet Venture cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Master Cylinder
Vehicle: 2002 Chevrolet Venture 3.4 V6 GAS
Master Cylinder
- On models equipped with manual brake system, disconnect master cylinder pushrod from brake pedal.
- On all models, disconnect all wire conne...
CLICK HERE TO GET FULL ACCESS TO 2002 Chevrolet Venture BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Chevrolet Venture AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Chevrolet Venture cars and light trucks from 1990+.
Hydraulic Brake Systems -> Adjustments -> Height Sensing Proportioning Valve
Vehicle: 2002 Chevrolet Venture 3.4 V6 GAS
Height Sensing Proportioning Valve
The height sensing proportioning valve must be adjusted whenever the valve and/or linkage is disassembled or removed for service. In addition, adjustment should be inspected if excessive front wheel lock-up is experienced with a lower than desired brake application rate when vehicle is at or near maximum GVWR.
- Raise and support vehicle, leave wheels on and allow axle to hang freely.
- Remove lever retaining nut and disconnect lever from valve shaft,. Fig. .
- Rotate valve shaft to permit installation of correct adjustment gauge,. Fig. , ensure D shaped hol...
CLICK HERE TO GET FULL ACCESS TO 2002 Chevrolet Venture BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
