2002 Ford Taurus Brake Service (ONLINE REPAIR MANUALS)

Pressure bleeding is recommended for all hydraulic disc brake systems.

Do not use brake fluid drained from the hydraulic system when bleeding the brakes. Ensure disc brake pistons are returned to their normal positions and the shoe and lining assemblies are properly seated. Before driving the vehicle, inspect the brake operation.

Do not shake the pressure bleeder tank while air is being added or after it has been pressurized. This will prevent air from the tank getting into the lines. Set the tank in the required location, then bring the air hose to the tank. Do not move the ta...

Brake Roughness

If roughness or vibration is encountered during highway operation or if pedal pumping is experienced at low speeds, the disc may have excessive thickness variation. Measure the disc at 12 points with a micrometer at a radius approximately one inch from the edge of the disc. If thickness measurements vary by more than .0005 inch, replace the rotor.

Excessive later...

Whenever new brake components are installed in the hydraulic system, it is recommended that the entire hydraulic system be thoroughly flushed with clean brake fluid.

It may sometime become required to flush out the system due to the presence of mineral oil, kerosene, gasoline, etc., which will cause swelling of rubber piston cups and valves and render them inoperative.

Flushing is performed at e...

Pressure bleeding is recommended for all hydraulic brake systems. Ensure all dirt and contaminants are removed from master cylinder area prior to removing reservoir cap.

To prevent air from the pressure tank getting into the lines, do not shake the tank while air is being added to the tank or after it has been pressurized. Set the tank in the required location, bring the air hose to the tank, and do not move it during the bleeding operation. The tank should be kept at least one-third full.

On vehicles equipped with disc brakes and master cylinders without proportioners or press...

Continental, Cougar, LS, Mustang, Sable & Taurus

Sliding caliper rear disc brakes are used on these models. The caliper is basically the same as the larger front wheel caliper. However, a parking brake mechanism and a larger inner brake shoe anti-rattle spring have been added.

The parking brake lever, located at the rear of the caliper, is actuated by a cable system similar to rear drum brake applications. When the parking brake is applied, the cable rotates the lever and operating shaft, driving the caliper piston and brake shoe assembly against the rotor. An automatic adjuster in th...

Master Cylinder Overhaul

Disassemble

• Clean outside of master cylinder thoroughly. Drain brake fluid from master cylinder.
• Remove stop bolt and pressure control valves, if equipped.
• Pry up on reservoir and remove it from master cylinder body.
• Remove fluid control valve, if equipped.
• Depress primary piston and remove snap ring from retaining groove at open end of bore.
• Remove primary and secondary piston assemblies from master cylinder. If secondary piston does not come out, apply air pressure to secondary outlet port to remove.

Inspection

When disassembled, wash all parts in clean brake...