2004 Dodge Grand Caravan Brake Service (ONLINE REPAIR MANUALS)

Caravan, Town & Country & Voyager

• Raise and support vehicle, then remove wheel and caliper as outlined under . Support caliper at all times to prevent brake hose damage.
• Slide brake rotor off hub.
• Reverse procedure to install. Clean brake rotor with alcohol or other suitable solvent.

Commander

Front

• Raise and support vehicle using suitable lift or jack.
• Remove tire and wheel assembly.
• Remove caliper as outlined in .
• Secure caliper anchor assembly using suitable wire.
• Remove and discard O-ring securing disc brake rotor on hub.
• Remove rotor from hub and bearing.
• Reverse procedure to install, n...

These vehicles are equipped with dual piston calipers, sliding single piston systems, single non-metallic calipers, floating caliper-single piston or single piston caliper mounted disc brake systems.

Upon brake application, fluid pressure exerted against the caliper piston increases equally in all directions, creating the same pressure in the caliper bore and on the piston.

Press...

Caravan, Town & Country & Voyager

Park Brake Shoes

• Set parking brake. Parking brake is set to keep hub/bearing and axle shaft from rotating when loosening hub nut.
• Raise and support vehicle allowing rear suspension to hang free.
• Remove rear wheels.
• Remove cotter pin and nut retainer from stub shaft of outer C/V joint.
• Remove spring washer, hub nut and washer from stub shaft of outer C/V joint.
• Release parking brake.
• Create slack in rear park brake by locking out automatic adjuster as follows:
• Grasp exposed section of front park brake and pull downward on it.
• Install a pair of suitab...

Manual

• Remove reservoir filler caps and fill reservoir with proper brake fluid.
• If calipers or wheel cylinders were overhauled, open all caliper and wheel cylinder bleed screws.
• Close each bleed screw as fluid starts to drip from them.
• Fill master cylinder reservoir once more before proceeding.
• Attach one end of bleed hose to bleed screw and insert opposite end in glass container partially filled with brake fluid, Fig. . Ensure bleed hose is immersed in fluid.
• Open up bleeder, then have an assistant press down brake pedal.
• Once brake pedal is down, close bleeder. Repeat bleeding unt...

Brake Shoe, Replace

Do not intermix automatic adjuster components from side to side.

9, 10, 11 & 13 Inch Drums

Caravan, Dakota, Town & Country & Voyager

Removal

• Raise and support vehicle, then remove rear wheels.
• Remove drum retaining nuts if equipped, then the drums. If drum will not separate from brake shoes or axle, proceed as follows:
• Ensure parking brake is disengaged.
• Remove adjuster hole plug from backing plate.
• Insert small screwdriver or equivalent, through adjuster hole, then push and hold self adjuster lever off adjuster screw assembly, Fig. .
• Back off adjuster screw assembly unt...

When wheel slip is detected during a brake application, the ABS enters anti-lock mode. During anti-lock braking, hydraulic pressure in the individual wheel circuits is controlled to prevent any wheel from slipping. A separate hydraulic line and specific solenoid valves are provided for each wheel. The ABS can decrease, hold, or increase hydraulic pressure to each wheel brake. The ABS cannot, however, increase hydraulic pressure above the amount which is transmitted by the master cylinder during braking.

During anti-lock braking, a series of rapid pulsations is felt in the brake pedal...