Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2005 Chevrolet Monte Carlo car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2005 Chevrolet Monte Carlo automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2005 Chevrolet Monte Carlo
- 2005 Chevrolet Monte Carlo LS 3.4 V6 GAS, CID:207, Fuel Injection, Aspiration:207, Engine VIN:, Desg:E
- 2005 Chevrolet Monte Carlo SS 3.8 V6 GAS, CID:231, Fuel Injection, Aspiration:231, Engine VIN:, Desg:1
- 2005 Chevrolet Monte Carlo LT 3.8 V6 GAS, CID:231, Fuel Injection, Aspiration:231, Engine VIN:, Desg:K
BRAKE SERVICE PROCEDURES FOR 2005 Chevrolet Monte Carlo AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Chevrolet Monte Carlo cars and light trucks from 1990+.
Power Brake Units -> Adjustments -> AC-Delco Tandem Diaphragm Type -> Air Method -> Brake Pedal -> Gauge Method -> Pushrod -> Toyota/GM Single Diaphragm Type
Vehicle: 2005 Chevrolet Monte Carlo LS 3.4 V6 GAS
Brake Pedal
Toyota/GM Single Diaphragm Type
- With engine running and brake pedal in rest position, measure distance between face of pedal and floor mat.
- Distance should be 5.850-6.244 inches.
- If distance is not as specified, adjust pedal height as follows:
- Remove lefthand lower instrument panel trim section and air duct.
- Loosen stop lamp switch sufficiently to access pedal adjustment.
- Loosen locknut and rotate pedal pushrod as required to obtain specified pedal height. Tighten locknut.
- Adjust brake lamp switch position so plunger lightly contacts pedal stopper and brake lamps are off when pe...
CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Monte Carlo BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Chevrolet Monte Carlo AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Chevrolet Monte Carlo cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Except ION & L-Series -> ION -> L-Series -> Master Cylinder
Vehicle: 2005 Chevrolet Monte Carlo LT 3.8 V6 GAS
Master Cylinder
Except ION & L-Series
- On Vibe models, remove air filer hose clamp and hose from throttle body.
- On all models, disconnect fluid level sensor retainer and electrical connector.
- Drain master cylinder reservoir brake fluid into suitable container.
- Plug hose.
- Disconnect master cylinder brake pipes. Plug open pipes.
- Remove mounting nuts and master cylinder.
- Remove reservoir, as required.
- Reverse procedure to install. Bleed hydraulic system as outlined in .
ION
- Remove underhood electrical center cover.
- Remove Connector Position Assurance (CPA) connector from brake fluid level...
CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Monte Carlo BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Chevrolet Monte Carlo AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Chevrolet Monte Carlo cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Rear Disc Brake -> Brake System Bleed -> Bleed Sequence -> Manual -> Pressure
Vehicle: 2005 Chevrolet Monte Carlo LT 3.8 V6 GAS
Manual
Pressure bleeding is recommended for all hydraulic systems. However, if a pressure bleeder is unavailable, use the following procedure. Brake fluid damages painted surfaces. Immediately clean any spilled fluid.
- Remove vacuum reserve by pumping brakes several times with engine off.
- Fill master cylinder reservoir with clean brake fluid. Do not let reservoir fall below half full during bleeding procedure.
- If required, bleed master cylinder as follows:
- Loosen master cylinder forward brake line connection until fluid flows from reservoir, then tighten brake line.
- Have assistant t...
CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Monte Carlo BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Chevrolet Monte Carlo AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Chevrolet Monte Carlo cars and light trucks from 1990+.
Anti-Lock Brakes -> Delphi DBC 7 -> Diagnosis & Testing -> Accessing Diagnostic Trouble Codes -> Alero, Cavalier, Grand Am, Malibu & Sunfire -> Century, Impala, Monte Carlo & Regal -> Clearing Diagnostic Trouble Codes -> Diagnostic Tests -> Diagnostic Trouble Code Interpretation -> EBCM Terminal Identification -> Electromagnetic Interference Test -> Intermittents & Poor Connections
Vehicle: 2005 Chevrolet Monte Carlo LT 3.8 V6 GAS
Accessing Diagnostic Trouble Codes
Diagnostic Trouble Codes (DTCs) may be read using a suitably programed scan tool. There are no provisions for flash code diagnostics.
- Turn ignition switch to Off position.
- Connect suitably programmed scan tool connected to Data Link Connector (DLC), located under lefthand side of instrument panel below steering column.
- Turn ignition switch to On position.
- Select scan tool Special Functions.
- Select and run Automated Test.
- Record all DTCs.
Diagnostic Trouble Code Interpretation
Connector numbers, circuit numbers and wire codes for individual models ma...
[[table data]] [[table data]] [[table data]] [[table data]]CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Monte Carlo BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Chevrolet Monte Carlo AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Chevrolet Monte Carlo cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Rear Disc Brake -> Description
Vehicle: 2005 Chevrolet Monte Carlo LS 3.4 V6 GAS
On all models except Century, Grand Prix and Regal,the caliper assembly has a single bore and is mounted to the support bracket with two mounting bolt and sleeve assemblies, Fig. . Hydraulic pressure created by applying the brake pedal is converted by the caliper to a stopping force. This force acts equally against the piston and the bottom of the piston bore to move the piston outward and to slide the caliper inward resulting in a clamping action. This clamping action presses the linings against the rotor, creating friction to stop the vehicle.
On Century, Grand Prix and Regal model...
CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Monte Carlo BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2005 Chevrolet Monte Carlo AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2005 Chevrolet Monte Carlo cars and light trucks from 1990+.
Disc Brakes -> AC-Delco Single Piston Rear Disc Brake -> Brake Pad Service -> All Models Except Century, Grand Prix & Regal -> Century, Grand Prix & Regal -> Installation -> Removal
Vehicle: 2005 Chevrolet Monte Carlo SS 3.8 V6 GAS
All Models Except Century, Grand Prix & Regal
Removal
- Remove 2/3 of brake fluid from master cylinder reservoir.
- Raise and support vehicle.
- Mark wheel to axle flange relationship for installation alignment, then remove wheel and tire assembly.
- Remove bolt and washer attaching cable support bracket to caliper, Fig. .
- Remove sleeve bolt and pivot caliper, Fig. . Do not completely remove caliper.
- Remove outboard and inboard shoe and linings, then two pad clips from caliper support.
Installation
- Turn piston and thread it into caliper assembly using suitable spanner-type tool in piston slots...
CLICK HERE TO GET FULL ACCESS TO 2005 Chevrolet Monte Carlo BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2005 Chevrolet Monte Carlo vehicle.
|
| Access the Complete guide! |
