Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2005 Ford Explorer Sport Trac car and truck
repair procedures including Ford engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2005 Ford Explorer Sport Trac automobile. Try the Automotix DIY solution today!
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Ford Explorer Sport Trac AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Ford Explorer Sport Trac cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Air Bag Warning Lamp ->
Vehicle: 2005 Ford Explorer Sport Trac 4.0 V6 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the Air Bag warning ...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Explorer Sport Trac MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Ford Explorer Sport Trac AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Ford Explorer Sport Trac cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Check Fuel Cap Lamp ->
Vehicle: 2005 Ford Explorer Sport Trac 4.0 V6 GAS
The Check Fuel Cap Lamp will illuminate momentarily when the ignition switch is placed in the On position as a bulb check. If the lamp remains...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Explorer Sport Trac MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Ford Explorer Sport Trac AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Ford Explorer Sport Trac cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Check Engine Lamp -> 1998-2006 EEC-V -> Keep Alive Memory (KAM) Reset & PCM Reset Less Electronic Tester -> PCM Reset Using Generic Scan Tool
Vehicle: 2005 Ford Explorer Sport Trac 4.0 V6 GAS
This lamp should light when the ignition is turned On. After engine starts, the lamp should go off, unless a fault condition is detected by the EEC-V system. If the lamp remains On or starts to blink, a diagnostic trouble code is stored in the PCM. Following diagnosis and repair, the Check Engine/MIL lamp will automatically reset when stored diagnostic trouble codes are cleared from PCM memory. The PCM reset procedure allows the scan tool to command the PCM to clear all diagnostic trouble codes.
A temporary fault such as running out of fuel, poor quality or water in fuel or loose...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Explorer Sport Trac MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Ford Explorer Sport Trac AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Ford Explorer Sport Trac cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Emission Maintenance Reminder Indicator ->
Vehicle: 2005 Ford Explorer Sport Trac 4.0 V6 GAS
This lamp should light after approximately 60,000 miles of operation, Fig. . The amber lens lamp is located on the instrument panel and has the word Emissions, Emiss or EGR printed on it. After performing the required emission control maintenance, the module must be replaced or reset, depending on type of module used. On module equipped with reset feature, reset the module as follows:
- Turn ignition Off.
- On Aerostar models, the module is located under the instrument panel near the bulkhead connector.
- On Bronco, Explorer and F-Series, the module is attached to the instrument cluster to the left of ...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Explorer Sport Trac MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Ford Explorer Sport Trac AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Ford Explorer Sport Trac cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Check Gauge Warning Lamp ->
Vehicle: 2005 Ford Explorer Sport Trac 4.0 V6 GAS
This indicator should light if any of the following conditions appear:
- Engine oil pressure drops below approxi...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Explorer Sport Trac MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2005 Ford Explorer Sport Trac AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2005 Ford Explorer Sport Trac cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Trucks -> Message Center -> 2003-07 Explorer & Mountaineer -> System Check
Vehicle: 2005 Ford Explorer Sport Trac 4.0 V6 GAS
System Check
The Message Center will perform a system inspection of monitored systems and will indicate either system is OK or a warning message. To perform the System Check proceed as follows:
- Place the ignition switch in the On position.
- Press Message Center Set Up button.
- From Set Up Menu select System Check.
- Press the RESET button to start system inspection.
- The Message Center will cycle through the monitored systems and display an OK or Warning Message for 4 seconds.
- Depressing the RESET button will cycle the Message Center through of the monitored systems.
- Pressing ...
CLICK HERE TO GET FULL ACCESS TO 2005 Ford Explorer Sport Trac MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
