2005 Ford Mustang Brake Service (ONLINE REPAIR MANUALS)

Whenever new brake components are installed in the hydraulic system, it is recommended that the entire hydraulic system be thoroughly flushed with clean brake fluid.

It may sometime become required to flush out the system due to the presence of mineral oil, kerosene, gasoline, etc., which will cause swelling of rubber piston cups and valves and render them inoperative.

Flushing is performed at e...

Replacement

On models with anti-lock brakes, the brake booster system must be depressurized before disconnecting any hydraulic lines or fittings. Depressurize the system by pumping the brake pedal at least 25 times with the ignition in the Off position.

Crown Victoria, Five Hundred, Freestyle, Fusion, Grand Marquis, LS, Marauder, Milan, MKZ, Montego, Sable, Taurus, Thunderbird, Town Car & Zephyr

Before removing calipers, mark lefthand and righthand calipers so they can be installed in their original position.

• On models equipped with air suspension, turn air suspension service switch...

Power brake operation concerns should be handled as if two separate systems exist.

• Inspect for faults in hydraulic system first.
• If hydraulic system is satisfactory, inspect power brake circuit.
• Press brake pedal firmly and then start engine.
• Pedal should fall away slightly and less pressure should be needed to maintain pedal in any position.
• Install of suitable pressure gauge in brake hydraulic system.
• Record pressure with engine off and power unit not operating.
• Maintain pedal height, start engine and record measurement.
• There should be substantial pressure increase in second measurem...

Five Hundred, Freestyle, Fusion, LS, Milan, MKZ, Montego, Mustang, Sable, Taurus & Zephyr

Sliding caliper rear disc brakes are used on these models. The caliper is basically the same as the larger front wheel caliper. However, a parking brake mechanism and a larger inner brake shoe anti-rattle spring have been added.

The parking brake lever, located at the rear of the caliper, is actuated by a cable system similar to rear drum brake applications. When the parking brake is applied, the cable rotates the lever and operating shaft, driving the caliper piston and brake shoe assembly again...

Disc brake service is critical because of the close tolerances required in machining the brake disc to ensure proper brake operation.

Maintaining close control of the shape of the rubbing surfaces is required to prevent brake roughness. In addition, the surface finish must be non-directional and maintained at a micro-inch finish. This is required to avoid pulls and erratic performance and promote long lining life and equal lining wear of both the lefthand and righthand brakes.

Do not attempt to refinish the rubbing surfaces unless precision equip...

Pressure bleeding is recommended for all hydraulic brake systems. Ensure all dirt and contaminants are removed from master cylinder area prior to removing reservoir cap.

To prevent air from the pressure tank getting into the lines, do not shake the tank while air is being added to the tank or after it has been pressurized. Set the tank in the required location, bring the air hose to the tank, and do not move it during the bleeding operation. The tank should be kept at least one-third full.

On vehicles equipped with disc brakes and master cylinders without proportioners or press...