Auto Parts Search
2007 Saab 9-3 CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Saab REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Component Locations
- Wiring Diagrams
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2007 Saab 9-3 AUTOMOBILES
CV AXLE SHAFT, Replace -> Install -> Remove
Vehicle: 2007 Saab 9-3 Aero 2.8 V6 GAS
Remove
- Raise and support vehicle.
- Remove wheel and tire assembly.
- Remove wheel hub center nut.
- Remove lower engine cover.
- On convertible models, remove chassis reinforcement at front subframe.
- On all models, remove steering swivel member bolt, lower swivel arm and place a wedge tool No. 83 95 238 or equivalent between swing arm and anti-roll bar.
- Detach brake hose from clip and ABS harness holder. Turn wheel for better access.
- Press out drive shaft from wheel hub about 10 mm, using puller tool No. 89 96 951or equivalent.
- If removing lefthand drive shaft, proceed as follows:
- Undo th...
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2007 Saab 9-3 AUTOMOBILES
Alternator, Replace
Vehicle: 2007 Saab 9-3 2.0T 2.0 L4 GAS
- Remove battery cover.
- Disconnect battery ground cable.
- Raise and support vehicle.
- Remove lower engine cover.
- Place a suitable container under vehicle, connect a hose to radiator and drain coolant.
- Remove right front wheel.
- Remove right wheelhouse liner.
- If drive belt is to be reused, mark direction of rotation.
- Rotate belt tensioner, using a suitable tool to relieve tension from drive belt.
- Remove drive belt.
- Lower vehicle.
- Remove upper engine cover.
- Disconnect connectors from engine control module.
- Remove engine control module.
- Disconnect intak...
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2007 Saab 9-3 AUTOMOBILES
Cabin Air Filter Service -> Saab -> 2003-09 9-3
Vehicle: 2007 Saab 9-3 Aero 2.8 V6 GAS
The cabin air filter should be replaced every 20,000 miles. The filter should be replaced more often if air flow is less than normal.
- Place wipers in the service position.
- Open the hood cover, then disconnect righthand side cover clips, Fig. .
- Loosen the rear main seal, lift off foam block then the front edge of the cover so that the hook and clip release on rear edge, Fig. .
- Fold cover ha...
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Saab 9-3 AUTOMOBILES
Saab -> Service Indicator -> 9-3 & 9-5 -> Automatic Reset -> Manual Reset
Vehicle: 2007 Saab 9-3 Aero 2.8 V6 GAS
Manual Reset
The Saab Information Display (SID) is equipped with a service indicator which shows the message TIME FOR SERVICE on the SID unit when it is time to service the vehicle.
The service message is shown when the day counter reaches 365 days or when 600 miles are left until next service. Refer to the following procedure to reset service indicator.
- Hold down clear button for at least 8 se...
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2007 Saab 9-3 AUTOMOBILES
Heater Hose, Replace -> Inlet -> Outlet
Vehicle: 2007 Saab 9-3 2.0T 2.0 L4 GAS
Inlet
- Drain coolant into a suitable container.
- Reposition inlet hose clamp at radiator and remove hose.
- Reposition inlet hose clamp at engine and remove hose.
- Remove hose from vehicle.
- Reverse procedure to i...
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2007 Saab 9-3 AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2007 Saab 9-3 Aero 2.8 V6 GAS
- Raise and support vehicle.
- Remove chassis reinforcement front subframe.
- Position suitable centering fixture on engine subframe and remove two long supports.
- Relieve load from engine and remove bolts attaching from spoiler shield.
- Lower the vehicle.
- Remove fasteners separating air cleaner assembly.
- Remove bolts from engine pad, then remove pad.
- Remove power steering pipe clip from engine mount.
- Remove ...
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 SERPENTINE BELT SERVICE PROCEDURES
COMPONENT LOCATION DIAGRAMS FOR 2007 Saab 9-3 AUTOMOBILES
Component location diagrams for most 2007 Saab 9-3 cars and light trucks sold in the U.S. from 1990+.
![]() Components on diagram: |
![]() Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 PARTS/COMPONENTS LOCATION DIAGRAMS!
WIRING DIAGRAMS FOR 2007 Saab 9-3 AUTOMOBILES
OEM drawn wiring diagrams for most 2007 Saab 9-3 cars and light trucks sold in the U.S.
![]() Components on diagram: |
![]() Components on diagram: |
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 WIRING DIAGRAMS!
TECHNICAL SERVICE BULLETINS FOR 2007 Saab 9-3 AUTOMOBILES
OEM TSB listings for most 2007 Saab 9-3 cars and light trucks sold in the U.S. from 1985+.
Document: GM of Canada New Vehicle Limited Warranty Tire Program Vehicle: 2007 Saab 9-3 Aero 2.8 V6 GAS Auto Systems: |
Document: New Website for AFIT, TPM, and VDR Updates Vehicle: 2007 Saab 9-3 Aero 2.8 V6 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2007 Saab 9-3 AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2007 Saab 9-3 cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2007 Saab 9-3 cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2007 Saab 9-3 cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2007 Saab 9-3 cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2007 Saab 9-3 SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |