Auto Parts Search
We have info for following modifications of 2008 Ford Taurus
- 2008 Ford Taurus SEL 3.5 V6 GAS, CC:3496, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:W
- 2008 Ford Taurus Limited 3.5 V6 GAS, CC:3496, CID:213, Fuel Injection, Aspiration:213, Engine VIN:, Desg:W
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Ford Taurus AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Ford Taurus cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Traction Control System Warning Lamp ->
Vehicle: 2008 Ford Taurus SEL 3.5 V6 GAS
This lamp should light for a approximately 6-8 seconds when the ignition is turned On as a bulb check. If the warni...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Taurus MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Ford Taurus AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Ford Taurus cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Service Interval Reminder -> 2008-09 Taurus & Taurus X
Vehicle: 2008 Ford Taurus Limited 3.5 V6 GAS
- Press and release SETUP button until System Check is displayed.
- Press SETUP button again to display OIL LIFE =XX% HOLD RESET = NEW.
- Press and hold RESET button for two seconds or longe...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Taurus MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Ford Taurus AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Ford Taurus cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Low Oil Level Warning Indicator ->
Vehicle: 2008 Ford Taurus Limited 3.5 V6 GAS
This system is used to indicate when the engine oil level is 11/2 quarts or more below the specified level. The lamp should light during engine starting. If the oil level is sufficient, the lamp will go off when the engine is operating. If the ...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Taurus MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Ford Taurus AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Ford Taurus cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Low Oil Level Warning Indicator ->
Vehicle: 2008 Ford Taurus SEL 3.5 V6 GAS
This system is used to indicate when the engine oil level is 11/2 quarts or more below the specified level. The lamp should light during engine starting. If the oil level is sufficient, the lamp will go off when the engine is operating. If the ...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Taurus MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Ford Taurus AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Ford Taurus cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2008-09 Taurus & Taurus X -> Relearn -> Reset -> TPMS Sensor Activation -> TPMS Sensor Training
Vehicle: 2008 Ford Taurus SEL 3.5 V6 GAS
Reset
If the system detects low tire pressure, CHECK TIRE PRESSURE lamp will illuminate. Inflating tire(s) to recommended pressure will clear the tire message. Up to two minutes of driving above 20 mph may be required for the warning lamp to turn OFF after the tires have been filled to the recommended pressure.
Relearn
TPMS Sensor Activation
To conserve battery power, the TPMS sensors will go into a sleep mode after approximately 30 minutes of inactivity. The sensors will not transmit tire pressure information while in sleep mode. The sensors must be activated to transmit ...
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Taurus MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2008 Ford Taurus AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2008 Ford Taurus cars and light trucks sold in the U.S. from 1990+.
Ford Motor Co. Cars -> Powertrain Malfunction Indicator ->
Vehicle: 2008 Ford Taurus SEL 3.5 V6 GAS
This lamp should light when the ignition is turned On. After engine starts, the lamp should go off, unless a fault condition is detected in the powertrain system. If the lamp remains On a diagnostic trouble code is stored in the PCM. Following diagnosis and repair, the Powertrain Malfunction Indicator will automatically reset when stored diagnostic trouble codes are cleared from PCM memory. The PCM reset procedure allows the scan tool to command the PCM to clear all diagnostic trouble codes.
CLICK HERE TO GET FULL ACCESS TO 2008 Ford Taurus MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2008 Ford Taurus vehicle. |
Access the Complete guide! |