Auto Parts Search

We have info for following modifications of 2009 Chevrolet Cobalt
- 2009 Chevrolet Cobalt SS 2.0 L4 GAS, CC:1998, CID:122, Fuel Injection, Aspiration:122, Engine VIN:, Desg:X
- 2009 Chevrolet Cobalt LS 2.2 L4 GAS, CC:2198, CID:134, Fuel Injection, Aspiration:134, Engine VIN:, Desg:H
- 2009 Chevrolet Cobalt LT 2.2 L4 GAS, CC:2198, CID:134, Fuel Injection, Aspiration:134, Engine VIN:, Desg:H
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Cobalt AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Cobalt cars and light trucks from 1990+.
Hydraulic Brake Systems -> Diagnosis & Testing
Vehicle: 2009 Chevrolet Cobalt LS 2.2 L4 GAS
Refer to...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Cobalt BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Cobalt AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Cobalt cars and light trucks from 1990+.
Disc Brakes -> GM Single Piston -> Brake System Bleed -> Bleed Sequence -> Manual -> Pressure
Vehicle: 2009 Chevrolet Cobalt LS 2.2 L4 GAS
Brake fluid is corrosive to painted surfaces. Care must be taken not to allow brake fluid to come in contact with painted surfaces on vehicle.
When bleeding the brake system, always bleed righthand rear wheel circuit first, followed by the lefthand front, lefthand rear and, finally, righthand front.
Manual
Pressure bleeding is recommended for all hydraulic systems. However, if a pressure bleeder is unavailable, use the following procedure. Brake fluid damages painted surfaces. Immediately clean any spilled fluid.
- Remove vacuum reserve by pumping brakes several times with engine o...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Cobalt BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Cobalt AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Cobalt cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed -> Bleed Sequence -> Manual -> Pressure
Vehicle: 2009 Chevrolet Cobalt LT 2.2 L4 GAS
Brake fluid is corrosive to painted surfaces. Care must be taken not to allow brake fluid to come in contact with painted surfaces on vehicle.
When bleeding the brake system, always bleed righthand rear wheel circuit first, followed by the lefthand front, lefthand rear and, finally, righthand front.
Manual
Pressure bleeding is recommended for all hydraulic systems. However, if a pressure bleeder is unavailable, use the following procedure. Brake fluid damages painted surfaces. Immediately clean any spilled fluid.
- Remove vacuum reserve by pumping brakes several times with engine o...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Cobalt BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Cobalt AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Cobalt cars and light trucks from 1990+.
Disc Brakes -> GM Single Piston -> Rotor Replace -> AURA, Cobalt, G5 & Malibu -> Solstice & SKY
Vehicle: 2009 Chevrolet Cobalt SS 2.0 L4 GAS
AURA, Cobalt, G5 & Malibu
- Raise and support vehicle, then remove tire and wheel assembly.
- Compress piston into caliper bore using suitable C-clamp to allow caliper pivot upward from brake pads.
- Install and tighten two wheel nuts opposite to retain rotor to hub.
- Remove guide pin bolts, caliper and bracket.
- Mark rotor to wheel studs for installation alignment and re...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Cobalt BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Cobalt AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Cobalt cars and light trucks from 1990+.
Disc Brakes -> GM Single Piston -> Caliper Service -> Assemble -> AURA, Cobalt, G5, Malibu, Solstice & SKY -> Disassemble -> Replacement
Vehicle: 2009 Chevrolet Cobalt LS 2.2 L4 GAS
AURA, Cobalt, G5, Malibu, Solstice & SKY
Replacement
- Raise and support vehicle, then remove tire and wheel assemblies.
- Install and tighten two wheel nuts opposite to retain rotor to hub.
- Tighten suitable C-clamp to compress piston into caliper bore.
- Remove mounting bolt and brake hose from caliper, Fig. .
- Remove and discard copper brake hose gaskets.
- Cap opening in brake caliper and brake hose.
- Remove guide pin bolts, caliper and bracket.
- Reverse procedure to install.
Disassemble
- Remove caliper piston from bore using compressed air through fluid inlet hole.
- Remove retaining...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Cobalt BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2009 Chevrolet Cobalt AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2009 Chevrolet Cobalt cars and light trucks from 1990+.
Power Brake Units -> Description -> AC-Delco Tandem Diaphragm Type -> GM/Toyota Single Diaphragm Type
Vehicle: 2009 Chevrolet Cobalt LT 2.2 L4 GAS
AC-Delco Tandem Diaphragm Type
This unit utilizes a vacuum power chamber, consisting of a front and rear shell, housing divider, front and rear diaphragm, plate assemblies, hydraulic pushrod and a diaphragm return spring, Fig. .
In normal operating mode, with service brakes in released position, the booster operates with vacuum on both sides of its diaphragms. When brakes are applied, air at atmospheric pressure is admitted to one side of each diaphragm to provide power assist. When the service brake is released, atmospheric air is shut off f...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Cobalt BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |