Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2009 Chevrolet Uplander car and truck
repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 2009 Chevrolet Uplander automobile. Try the Automotix DIY solution today!
We have info for following modifications of 2009 Chevrolet Uplander
- 2009 Chevrolet Uplander 3.9 V6 GAS, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:1
- 2009 Chevrolet Uplander LS 3.9 V6 GAS, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:1
- 2009 Chevrolet Uplander LT 3.9 V6 GAS, CC:3880, CID:237, Fuel Injection, Aspiration:237, Engine VIN:, Desg:1
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Chevrolet Uplander AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2009 Chevrolet Uplander cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2009 Chevrolet Uplander 3.9 V6 GAS
Front
- Raise and support vehicle, then remove tire and wheel assembly.
- Remove engine splash shield.
- Insert a suitable drift or punch through brake caliper and into brake rotor to prevent wheel hub and bearing from turning.
- Remove wheel drive shaft spindle nut.
- Remove stabilizer shaft link.
- Disconnect outer tie rod end from steering knuckle. Do not loosen tie rod end jam nut.
- Disconnect wheel speed sensor electrical connector, then reposition wiring harness away from ball joint.
- Disconnect lower ball joint from steering knuckle.
- Install wheel hub remover tool No. J 42129, or equival...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Uplander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Chevrolet Uplander AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2009 Chevrolet Uplander cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2009 Chevrolet Uplander LS 3.9 V6 GAS
Front
- Raise and support vehicle, then remove tire and wheel assembly.
- Remove engine splash shield.
- Insert a suitable drift or punch through brake caliper and into brake rotor to prevent wheel hub and bearing from turning.
- Remove wheel drive shaft spindle nut.
- Remove stabilizer shaft link.
- Disconnect outer tie rod end from steering knuckle. Do not loosen tie rod end jam nut.
- Disconnect wheel speed sensor electrical connector, then reposition wiring harness away from ball joint.
- Disconnect lower ball joint from steering knuckle.
- Install wheel hub remover tool No. J 42129, or equival...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Uplander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Chevrolet Uplander AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2009 Chevrolet Uplander cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2009 Chevrolet Uplander LT 3.9 V6 GAS
- Raise and support vehicle using a suitable lift.
- Reference mark propeller shaft at transfer case flange.
- Remove propeller shaft-to-transfer case flange bolts.
- Reference mark propeller shaft at torque tube flange.
- Remove propeller shaft-to-torque tube flange bol...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Uplander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Chevrolet Uplander AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2009 Chevrolet Uplander cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2009 Chevrolet Uplander 3.9 V6 GAS
- Raise and support vehicle using a suitable lift.
- Reference mark propeller shaft at transfer case flange.
- Remove propeller shaft-to-transfer case flange bolts.
- Reference mark propeller shaft at torque tube flange.
- Remove propeller shaft-to-torque tube flange bol...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Uplander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Chevrolet Uplander AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2009 Chevrolet Uplander cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2009 Chevrolet Uplander LT 3.9 V6 GAS
Front
- Raise and support vehicle, then remove tire and wheel assembly.
- Remove engine splash shield.
- Insert a suitable drift or punch through brake caliper and into brake rotor to prevent wheel hub and bearing from turning.
- Remove wheel drive shaft spindle nut.
- Remove stabilizer shaft link.
- Disconnect outer tie rod end from steering knuckle. Do not loosen tie rod end jam nut.
- Disconnect wheel speed sensor electrical connector, then reposition wiring harness away from ball joint.
- Disconnect lower ball joint from steering knuckle.
- Install wheel hub remover tool No. J 42129, or equival...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Uplander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Chevrolet Uplander AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2009 Chevrolet Uplander cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 2009 Chevrolet Uplander LS 3.9 V6 GAS
- Raise and support vehicle using a suitable lift.
- Reference mark propeller shaft at transfer case flange.
- Remove propeller shaft-to-transfer case flange bolts.
- Reference mark propeller shaft at torque tube flange.
- Remove propeller shaft-to-torque tube flange bol...
CLICK HERE TO GET FULL ACCESS TO 2009 Chevrolet Uplander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 2009 Chevrolet Uplander vehicle.
|
| Access the Complete guide! |
