Auto Parts Search
2009 Dodge Charger CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Dodge REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Brake Service
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service

BRAKE SERVICE PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
Hydraulic Brake Systems -> Hydraulic Brake Control Specifications
Vehicle: 2009 Dodge Charger SE 3.5 V6 GAS
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger BRAKE SERVICE PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
DRIVESHAFT, Replace
Vehicle: 2009 Dodge Charger SXT 3.5 V6 GAS
- Raise and support vehicle on hoist.
- Mark transmission and axle flanges and rubber couplers for installation alignment.
- Remove crossmember, rear exhaust system and heat shield.
- Remove propeller shaft front and rear coupler-to-flange bolts.
- Remove center bearing mounting bolts.
- Remove propeller shaft with aid of helper. Never allow propeller shaft to hang from center bearing, or while only connected to transmission or rear axle flanges.
- Remove three couple...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
Reset Procedures
Vehicle: 2009 Dodge Charger SE 3.5 V6 GAS
The Low Tire Pressure indicator lamp will flash slowly and sound a single tone when tire pressure is low. If tire pressure drops lower, the indicator lamp will flash rapidly and the tone will be continuous. When the tire is inflated to the proper pressure the lamp and tone will ...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
Starter, Replace
Vehicle: 2009 Dodge Charger SE 3.5 V6 GAS
- Disconnect and isolate battery ground cable at battery.
- Remove left side catalytic converter.
- Remove battery cable nut and battery cable from solenoid stud.
- Disconnect electrical connector from starter solenoid terminal.
- Remove starter mounting bolts, electrical harness mounting bracket should remain...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
Cabin Air Filter Service -> Chrysler LLC -> 2005-09 300, Magnum, 2006-09 Charger & 2008-09 Challenger
Vehicle: 2009 Dodge Charger R/T 5.7 V8 GAS
The cabin air filter should be replaced every 12,000 miles.
- Open the hood.
- Remove the passenger side air inlet grille from the cowl panel, Fig. .
- Open the cabin air filter door.
- Remove the cabin air filter from the filter housing...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
Chrysler LLC Cars -> Check Engine Lamp -> Charger, Magnum & 300C
Vehicle: 2009 Dodge Charger R/T 5.7 V8 GAS
The Powertrain Control Module (PCM) monitors a variety of sensors and systems. Each time the ignition is turned On, the instrument panel Malfunction Indicator Lamp (MIL) should light for approximately 2 seconds and then go out. If the PCM senses a fault condition with a monitored circuit or if the PCM enters Limp-In mode, a Diagnostic Trouble Code (DTC) in is stored in the PCM memory. After diagnosing and servicing the vehicle, use a suitable scan tool to erase DTCs and to reset the MIL.
The lamp illuminates when the ignition is first turned to the on position to check th...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
Heater Hose, Replace -> Inlet -> Outlet
Vehicle: 2009 Dodge Charger SE 2.7 V6 GAS
Inlet
- Drain coolant into a suitable container.
- Loosen hose clamp connecting hose to heater core inlet tube.
- Loosen hose clamp connecting hose to heater tube.
- Remove hose from vehicle.
- Reverse procedure to...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Dodge Charger AUTOMOBILES
Serpentine Drive Belt, Replace -> Installation -> Removal
Vehicle: 2009 Dodge Charger SXT 3.5 V6 GAS
Removal
- Rotate belt tensioner counterclockwise until it contacts a stop.
- Remove belt and slowly rotate tensioner into the freearm position. Do not let tensioner arm snap back to freearm position.
Installation
- Route belt around all pulleys except idler pulley.
- Rotate tensioner arm until it contacts a s...
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Dodge Charger AUTOMOBILES
OEM TSB listings for most 2009 Dodge Charger cars and light trucks sold in the U.S. from 1985+.
Document: Hard To Fill Or Fuel Nozzle Shuts Off Repeatedly Vehicle: 2009 Dodge Charger SXT 3.5 V6 GAS Auto Systems: |
Document: Steering Wheel Returnability Vehicle: 2009 Dodge Charger SXT 3.5 V6 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Dodge Charger AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Dodge Charger cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Dodge Charger cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Dodge Charger cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Dodge Charger cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Dodge Charger SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |