Auto Parts Search
2009 Mitsubishi Outlander CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Mitsubishi REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Mitsubishi Outlander AUTOMOBILES
CV AXLE SHAFT, Replace
Vehicle: 2009 Mitsubishi Outlander ES 2.4 L4 GAS
Do not strike ABS rotors or outer race of driveshaft against other parts when removing or installing driveshaft. Use care not to strike pole piece at tip of front wheel speed sensor with tools when servicing vehicle.
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front wheels.
- Remove drain plug on transaxle and drain in suitable container.
- On models equipped with AWD, drain transfer case fluid into suitable container.
- On all models, remove bolts and nuts securing front exhaust pipe.
- Remove wheel hub cotter pin, nut, and w...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Mitsubishi Outlander AUTOMOBILES
Component Replacement -> Tightening Specifications -> TPMS Receiver -> TPMS Transmitter
Vehicle: 2009 Mitsubishi Outlander XLS 3.0 V6 GAS
When a TPMS transmitter or receiver is replaced, register the tire pressure sensor ID of all TPMS transmitter contained tires.
When a TPMS antenna and feeder cable are replaced, register the tire pressure sensor ID of all tires with a TPMS transmitter and then ensure that the receiver is functioning correctly through the completion of the registration.
TPMS Receiver
- Remove ignition key cover, Fig. .
- Remove upper and lower steering column covers.
- Remove screw, then remote the TPMS receiver.
- Reverse procedure to install noting the following:
- If TPMS receiver was replaced, perform "T... "
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Mitsubishi Outlander AUTOMOBILES
Starter, Replace
Vehicle: 2009 Mitsubishi Outlander ES 2.4 L4 GAS
- Remove battery and battery tray.
- Remove air cleaner intake duct and air cleaner intake hose.
- Remove engine room front covers.
- Disconnect emission vacuum hose and brake booster vacuum hose.
- Remove throttle body stay.
- Remove...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Mitsubishi Outlander AUTOMOBILES
Cabin Air Filter Service -> Mitsubishi -> Endeavor & 2007-09 Outlander
Vehicle: 2009 Mitsubishi Outlander ES 2.4 L4 GAS
Under normal operating conditions the cabin air filter should be replaced every 15,000 miles. In dusty areas change the cabin air filter more often.
- Open the glove compartment.
- Disengage the glove compartment lid.
- Disconnect the glove compartment lamp, then remove the glove compartment.
- Disengage the two lugs securing the cabin air filter cover, then re...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Mitsubishi Outlander AUTOMOBILES
Mitsubishi -> Tire Pressure Monitoring System (TPMS) Warning Indicator -> 2008-09 Outlander -> Relearn -> Reset -> Tire Pressure Sensor ID Registration -> Warning Lamp
Vehicle: 2009 Mitsubishi Outlander SE 2.4 L4 GAS
Reset
Tire Pressure Sensor ID Registration
- Connect a suitable scan tool to vehicle data link connector, Fig. .
- Follow scan tool instructions to enter "Tire Pressure Sensor ID Registration" mode.
- Select the number of tires that you want to register.
- Starting at any TPMS transmitter, emit a signal from the transmitter as follows:
- Decrease the tire pressure to 25.2 psi or less by changing 2.9 psi or more, and register the TPMS transmitter ID code of each wheel to TPMS receiver
- Verify that a signal has been received by the TPMS receiver us...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Mitsubishi Outlander AUTOMOBILES
Coolant Hose, Replace -> Lower -> Upper
Vehicle: 2009 Mitsubishi Outlander SE 2.4 L4 GAS
Lower
- Disconnect battery ground cable.
- Drain cooling system into a suitable container by loosening drain plug of radiator.
- Reposition hose clamp at radiator outlet.
- Remove hose from radiator.
- Reposition hose clamp at water inlet.
- Remove hose from water inlet.
- Remove hose from vehicle.
- Reverse procedure to instal...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Mitsubishi Outlander AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Mitsubishi Outlander XLS 3.0 V6 GAS
- Raise and support vehicle.
- Remove both side and rear engine under covers.
- Rotate auto-tensioner counterclockwise, using a suitab...
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Mitsubishi Outlander AUTOMOBILES
OEM TSB listings for most 2009 Mitsubishi Outlander cars and light trucks sold in the U.S. from 1985+.
Document: RKE INTEGRATED KEY CASE SERVICE PARTS KIT AVAILABILITY Vehicle: 2009 Mitsubishi Outlander XLS 3.0 V6 GAS |
Document: CHANGE IN OUTPUT VOLTAGE FROM ENGINE ECM - SERVICE MANUAL REVISION Vehicle: 2009 Mitsubishi Outlander XLS 3.0 V6 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Mitsubishi Outlander AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Mitsubishi Outlander cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Mitsubishi Outlander cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Mitsubishi Outlander cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Mitsubishi Outlander cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Mitsubishi Outlander SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |