Auto Parts Search
2009 Subaru Tribeca CAR/TRUCK REPAIR PROCEDURES AND DIAGRAMS - WHAT Subaru REPAIR SHOPS DON'T WANT YOU TO KNOW
Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!Select Section
- Technical Service Bulletins
- Specifications
- Driveline, U-Joint & CV Axles Replacement
- Tire Pressure Monitoring System
- Starter & Alternator Replacement
- Cabin Air Filter Locations & Replacement
- Maintenance Lamp Reset
- Radiator & Hose Replacement
- Serpentine Belt Service
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2009 Subaru Tribeca AUTOMOBILES
CV AXLE SHAFT, Replace -> Front -> Rear
Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS
Front
- Disconnect battery ground cable.
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front wheels.
- Remove brake caliper bolts and support caliper to strut housing using mechanics wire.
- Remove disc brake rotor. If brake rotor is difficult to remove, drive 8mm bolt into threaded end of rotor, then remove the rotor. Reference mark surface of hub and disc rotor before removing disc rotor to prevent confusion during installation.
- Unstake hub nut using suitable tool.
- Remove driveshaft locknut from front hub while depressing brak...
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
TIRE PRESSURE MONITORING SYSTEM PROCEDURES FOR 2009 Subaru Tribeca AUTOMOBILES
Relearn Procedures -> Transmitter ID Registration
Vehicle: 2009 Subaru Tribeca 3.6 H6 GAS
Transmitter ID Registration
The following procedure must be performed when tire pressure sensor or TPMS control module is replaced. If tire pressure sensor transmitter ID cannot be registered after two attempts, replace the TPMS control module. If the registration procedure is not performed for 5 minutes or more or if the ignition switch is placed in the Off position, the registration mode will be cancelled.
- Check and adjust all tires to the recommended pressure.
- Connect the Subaru Select Monitor tool, or equivalent tool, then select Each System Check, Tire Pressure Monitor and ...
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca TIRE PRESSURE MONITORING SYSTEM PROCEDURES
STARTER & ALTERNATOR REPLACEMENT PROCEDURES FOR 2009 Subaru Tribeca AUTOMOBILES
Alternator, Replace
Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS
- Remove retainers securing engine cover.
- Disconnect battery ground cable.
- Remove terminal nut and alternator electrical connector from back of alternator.
- Rotate or lift belt tensioner arm clockwise using a suitable...
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca STARTER & ALTERNATOR REPLACEMENT PROCEDURES
CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES FOR 2009 Subaru Tribeca AUTOMOBILES
Cabin Air Filter Service -> Subaru -> 2006-09 B9 Tribeca
Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS
The cabin air filter should be replaced every 15 months or 15,000 miles.
- Remove the instrument panel side cover.
- Disconnect the glove compartment strap.
- Remove the glove compartment retaining clip, the glove compartment, Fig. .
- Through the glove compartment opening, remove the cabi...
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca CABIN AIR FILTER LOCATIONS & REPLACEMENT PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2009 Subaru Tribeca AUTOMOBILES
Subaru -> Check Engine Lamp -> 2008-09 Tribeca
Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS
The Check Engine lamp will be illuminated when the ignition switch is placed in the On position. When the engine is started, the lamp should go out. If it remains lit after engine start-up, the self-diagnostic system has detected a problem and stored a diagnostic trouble code. After diagnosis and repair are complete, the self-diagnostic system memory can be cleared using the scan tool. Follow scan to...
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca MAINTENANCE LAMP RESET PROCEDURES
RADIATOR & HOSE REPLACEMENT PROCEDURES FOR 2009 Subaru Tribeca AUTOMOBILES
Heater Hose, Replace -> Bypass -> Inlet -> Outlet
Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS
Inlet
- Drain cooling system into a suitable container.
- Reposition heater hose inlet clamp at water outlet using hose clamp pliers.
- Remove heater inlet hose from water outlet.
- Reposition heater core inlet hose clamp at heater core using hose clamp pliers.
- Remove hose from vehicle.
- Reverse procedure to install.
Outlet
- Drain cooling system into a suitable container.
- Reposition heater hose outlet clamp at water inlet using hose clamp pliers.
- Disco...
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca RADIATOR & HOSE REPLACEMENT PROCEDURES
SERPENTINE BELT SERVICE PROCEDURES FOR 2009 Subaru Tribeca AUTOMOBILES
Serpentine Drive Belt, Replace
Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS
- Remove bolts from collector cover, then remove cover.
- Rotate or lift the belt tensioner arm clockwise, using a suitable ...
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca SERPENTINE BELT SERVICE PROCEDURES
TECHNICAL SERVICE BULLETINS FOR 2009 Subaru Tribeca AUTOMOBILES
OEM TSB listings for most 2009 Subaru Tribeca cars and light trucks sold in the U.S. from 1985+.
Document: RES Immobilizer Antenna Ring Clip Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS |
Document: Service Manual Corrections Vehicle: 2009 Subaru Tribeca Limited 3.6 H6 GAS Auto Systems: |
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca TECHNICAL SERVICE BULLETINS!
COMPONENT/PARTS SPECIFICATIONS FOR 2009 Subaru Tribeca AUTOMOBILES
BRAKE SPECIFICATIONS: Brake drum, rotor, caliper, and related specifications for most 2009 Subaru Tribeca cars and light trucks sold in the U.S. and Canada from 1970+.
- Brake caliper mounting bolt torque
- Brake drum runout, machining, & discard specs
- Minimum brake lining thickness.
- Brake rotor runout, parallelism, machining, discard, & finish specs
A/C SYSTEM SPECIFICATIONS: Air conditioning refrigerant capacity and type as well as lubricant capacity for most 2009 Subaru Tribeca cars and light trucks sold in the U.S. and Canada from 1980+.
- Refrigerant capacity & type, compressor oil viscosity, total system oil capacity & compressor clutch gap
COOLING SYSTEM BLEED: Cooling system bleeder valve identification, bleeder type and bleed procedures for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1986+.
PREVENTIVE MAINTENANCE: Preventive maintenance recommendations and required services for most domestic and imported cars and light trucks sold in the U.S. and Canada from 1980+. Includes severe and routine service schedules
QUICK-LUBE and ILLUSTRATIONS: Fluid recommendations, capacities, drain plug torques, tire data, and severe service recommended preventive maintenance schedules. Information covers most 2009 Subaru Tribeca cars and light trucks sold in the U.S. and Canada from 1980+. Engine and chassis service images.
- Automatic transmission/transaxles capacities, lubricant recommendations
- Differential/final drive capacities, lube recommendations, grades, & viscosities
- Final drive fill & drain plug torques
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Manual transmission/transaxle capacities, lube recommendations, grades, & viscosities
- Number of lubrication fittings & plugs
- Power steering, brake, & clutch fluid recommendations
- Engine oil capacities, API grade recommendations, SAE viscosity recommendations, drain plug torque
- Severe service maintenance & interval recommendations
- Tire sizes, wheel nut/bolt torque, pressures & rim sizes
- Transfer case capacities, lube recommendations, grades, & viscosities
TUNE-UP & DRIVEABILITY SPECIFICATIONS: Most tune-up specifications for most 2009 Subaru Tribeca cars and light trucks sold in the U.S. and Canada from 1980+
- Airflow sensor electrical specifications
- Tensioning specifications for systems with automatic tensioners
- Barometric pressure sensor specs
- Battery group number and cranking performance
- Crankshaft & camshaft position sensor resistance
- Engine compression pressures
- Coolant temperature sensor specs
- Computer advance.
- Diesel fuel temperature sensor resistance.
- Distributor advance specifications
- Ignition pickup coil resistance
- Exhaust gas recirculation temperature sensor resistance
- Engine fastener torque values
- Firing order diagrams
- Fuel system pressures
- Generator (alternator) specs
- Intake air temperature sensor specs
- Ignition coil specifications
- Fuel injector resistance
- Engine idle speeds
- Knock sensor resistance
- Manifold absolute pressure sensor specs
- Mixture control solenoid resistance
- Voltage regulator specs
- Spark plug applications & gaps
- Starter motor electrical specs.
- Tensioning specifications for systems without automatic tensioners
- Throttle body temperature sensor resistance
- Ignition timing in degrees at rpm
- Transmission oil temperature sensor resistance
- Throttle position sensor specs
- Vacuum sensor valve specs
CLICK HERE TO GET FULL ACCESS TO 2009 Subaru Tribeca SPECIFICATIONS DATA!
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2009 Subaru Tribeca vehicle. |
Access the Complete guide! |