1998 Chevrolet K2500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Battery Ground Cable

Prior to service disconnect battery ground cable and isolate as required.

Radio Security System

Theftlock

If the Theftlock system is active when battery power is interrupted, the customers security code must be entered to restore proper function of the radio. To unlock a secured radio after power loss, proceed as follows:

• "LOC" appears with ignition in On position.
• Press "NM" and "000" will appear on display.
• Press "NM" again to make last two digits agree with security code.
• Press "HR" to make first 1 or 2 digits agree with security code.
• Press "AM-FM" to select code entered. "SEC" wi...

Removal

Front

• Siphon brake fluid out of master cylinder until fluid level is approximately ^1/3 full, this will prevent fluid overflow when caliper piston is pushed back into its bore.
• Raise and support vehicle, then remove wheels.
• Push piston back into its bore using suitable C-clamp, Fig. .
• Remove two caliper mounting bolts and lift caliper off of rotor.

Rear

Blazer, Bravada & Jimmy

• Raise and support vehicle.
• Mark position of wheel to hub for installation reference.
• Remove wheel assembly.
• Remove mounting bolt and disconnect brake hose fitting from caliper. Discard gaskets and plug brake h...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

Astro & Safari

• Apply parking brake.
• Disconnect reservoir and power steering hoses from booster.
• Remove master cylinder to brake booster retaining nuts.
• Position and support master cylinder away from booster. Do not remove hydraulic lines from master cylinder.
• Remove booster rod from top of brake pedal.
• Remove booster mounting nuts from inside of vehicle.
• Remove booster assembly and gasket.
• Reverse procedure to install, noting the following:
• Torque booster mounting nuts to 27 ft. lbs.
• Torque master cylinder retaining nuts to 27 ft. lbs.
• Torque power steering hoses to booster n...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...