Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1998 Suzuki X-90 car and truck
repair procedures including Suzuki engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 1998 Suzuki X-90 automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR 1998 Suzuki X-90 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Suzuki X-90 cars and light trucks from 1990+.
Anti-lock Brakes -> Troubleshooting
Vehicle: 1998 Suzuki X-90 JLX 1.6 L4 GAS
Refer to "Diagnosis & T... "
CLICK HERE TO GET FULL ACCESS TO 1998 Suzuki X-90 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Suzuki X-90 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Suzuki X-90 cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Assemble -> Disassemble -> Installation -> Removal
Vehicle: 1998 Suzuki X-90 JLX 1.6 L4 GAS
Removal
- Remove approximately 2/3 of brake fluid from master cylinder.
- Raise and support vehicle.
- Mark relationship between front wheel and axle, then remove wheel and tire assembly.
- Remove inlet fitting attaching bolt, copper washer and inlet fitting from caliper housing. Plug opening in inlet fitting to prevent fluid loss and contamination. Do not crimp brake hose, as this may damage internal structure of hose. If only shoe and lining assemblies are to be replaced, do not disconnect brake line fitting from caliper.
- Remove caliper slide pins and caliper.
- Remove shoe and lining assembl...
CLICK HERE TO GET FULL ACCESS TO 1998 Suzuki X-90 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Suzuki X-90 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Suzuki X-90 cars and light trucks from 1990+.
Drum Brakes -> Brake Service -> Brake Drum, Replace -> Brake Shoe, Replace -> Esteem -> Esteem & Swift -> Grand Vitara, Sidekick, Vitara & X-90 -> Swift -> Wheel Cylinder, Replace
Vehicle: 1998 Suzuki X-90 JLX 1.6 L4 GAS
Brake Drum, Replace
Esteem
- Raise and support vehicle, then remove wheel.
- Remove drum screws.
- Release parking brake lever.
- Remove parking brake lever cover, then loosen parking brake cable locking nut.
- To increase clearance between shoe and drum, proceed as follows:
- Remove backing plate plug.
- Insert screwdriver into plug hole till its tip contacts shoe hold-down spring, then push hold-down spring as shown, Fig. .
- Remove brake drum by fitting two 8 mm bolts into holes on drum and extracting drum off wheel hub.
- Reverse procedure to install, noting the following:
- Before installing drum, maximize...
CLICK HERE TO GET FULL ACCESS TO 1998 Suzuki X-90 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Suzuki X-90 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Suzuki X-90 cars and light trucks from 1990+.
Power Brake Units -> Power Brake Unit Service -> Brake Booster Overhaul -> Esteem, Grand Vitara, Sidekick, Vitara & X-90 -> Power Brake Unit, Replace -> Swift
Vehicle: 1998 Suzuki X-90 JLX 1.6 L4 GAS
Power Brake Unit, Replace
- Remove master cylinder from booster as outlined under " Master Cylinder, Replace," in "Hydraulic Brakes."
- Disconnect pushrod clevis from brake pedal arm.
- Disconnect vacuum hose from booster.
- Remove booster attaching nuts, then the booster assembly.
- Reverse procedure to install, then ensure brake pedal height and pedal travel is correct as outlined under "Brake Pedal Height, Adjust," and "Brake Pedal Travel Check" in "Hydraulic Brakes."
Brake Booster Overhaul
Swift
Refer to Fig., when performing this procedure.
- Remove piston rod from booster, then the pushrod clev...
CLICK HERE TO GET FULL ACCESS TO 1998 Suzuki X-90 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Suzuki X-90 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Suzuki X-90 cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service -> Master Cylinder Overhaul
Vehicle: 1998 Suzuki X-90 JLX 1.6 L4 GAS
Master Cylinder Overhaul
- Remove master cylinder as outlined under "Master Cylinder, Replace."
- Remove circlip, then the primary piston.
- Remove pisto...
CLICK HERE TO GET FULL ACCESS TO 1998 Suzuki X-90 BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1998 Suzuki X-90 AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1998 Suzuki X-90 cars and light trucks from 1990+.
Power Brake Units -> Description
Vehicle: 1998 Suzuki X-90 JLX 1.6 L4 GAS
When the brake pedal is depressed, a vacuum builds up in the booster which amplifies the pedal force, pressing on the piston in the master cylinder. The piston raises the hydraulic pressure in the cylinder. This hydraulic pres...
CLICK HERE TO GET FULL ACCESS TO 1998 Suzuki X-90 BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
