1999 Chevrolet K2500 Pickup Brake Service (ONLINE REPAIR MANUALS)

Delco Master Cylinder

When performing the following procedures, refer to Figs. and noting that the composite reservoir may vary in design.

Disassemble

• Remove master cylinder from vehicle.
• Remove reservoir cover and diaphragm. Discard old brake fluid in reservoir.
• Inspect cover and diaphragm. Replace if cut, cracked or deformed.
• Remove fluid level switch and proportioning valve assembly, if equipped.
• Depress primary piston and remove lock ring.
• Plug primary fluid outlet (outlet nearest to cowl when master cylinder is installed), then apply compressed air into secondary fluid outlet t...

Certain general service procedures apply, regardless of whether the brakes are vacuum or hydraulically assisted. Only top quality, clean brake fluid should be used. More seals and valves are used with power brake systems than with ordinary brakes, so an inferior brake fluid will do much more damage. For the same reason, ensure all dirt is kept out of the system. Additionally, on models with hydraulic assist brakes, care must be taken not to mix the fluids of the booster hydraulic system and brake hydraulic system as the fluids are not compatible.

If the power unit fails, the brak...

Accessing Diagnostic Trouble Codes

Diagnostic trouble codes (DTCs) can only be read by connecting a suitably programmed scan tool to the Data Link Connector (DLC) and following the tool manufacturer instructions.

Diagnostic Trouble Code Interpretation

Refer to Figs. and , for Diagnostic Trouble Code (DTC) interpretation.

Wiring Diagrams

Refer "Wiring Diagrams" in "Vehicle Systems"

Connector Pin ID

On 2000 S & T Series only, ensure correct anti-lock brake system connector pin identifications are used.

Diagnostic Process

• Inspect master cylinder reservoir fluid level and for possible fluid...

Battery Ground Cable

Prior to service disconnect battery ground cable and isolate as required.

Radio Security System

Theftlock

If the Theftlock system is active when battery power is interrupted, the customers security code must be entered to restore proper function of the radio. To unlock a secured radio after power loss, proceed as follows:

• "LOC" appears with ignition in On position.
• Press "NM" and "000" will appear on display.
• Press "NM" again to make last two digits agree with security code.
• Press "HR" to make first 1 or 2 digits agree with security code.
• Press "AM-FM" to select code entered. "SEC" wi...

Master Cylinder

Some vehicles use a conventional tandem master cylinder with two hydraulic pistons operating in-line. The primary piston controls the front brake system and the secondary piston controls the rear brake system.

Other models use a master cylinder that operates the same as the conventional master cylinder, but also incorporates a quick take-up feature in the rear chamber to reduce excessive pedal travel which may result from increased fluid displacement required to move the low drag caliper piston out against the rotor.

The quick take-up uses a spring-loaded ball check val...

Manual Bleed

• If vehicle is equipped with power brakes, remove vacuum reserve by applying brakes several times with engine off.
• Fill master cylinder reservoirs with suitable brake fluid. Ensure to always keep master cylinder reservoirs at least half full during entire bleeding procedure.
• If master cylinder is suspected to have air in the bore, it must be bled first. To bleed master cylinder, proceed as follows:
• Disconnect forward brake pipe connection at master cylinder.
• Allow brake fluid to fill master cylinder bore until it begins to flow from forward pipe connector port.
• Connect ...