Auto Parts Search

We have info for following modifications of 2002 Jaguar XKR
- 2002 Jaguar XKR 4.0 V8 GAS, CC:3996, CID:244, Fuel Injection, Aspiration:244, Engine VIN:, Desg:B
- 2002 Jaguar XKR 100 4.0 V8 GAS, CC:3996, CID:244, Fuel Injection, Aspiration:244, Engine VIN:, Desg:B
BRAKE SERVICE PROCEDURES FOR 2002 Jaguar XKR AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Jaguar XKR cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Service -> Master Cylinder
Vehicle: 2002 Jaguar XKR 4.0 V8 GAS
Master Cylinder
- Remove master cylinder as outlined in this section.
- Carefully pry out master cylinder hydraulic line adapters from sealing grommets.
- Remove sealing grommets from master cylinder by levering out using suitable screwdriver.
- Press primary piston stop pin in to relieve secondary piston stop pin pressure.
- Remove front grommet sealing housing stop pin. Maintain pressure on primary piston and remove cir-clip.
- Remove primary/secondary pistons and spring assemblies by tapping master cylinder open flanged end on suitable wooden block. Compressed air may have to be applied to m...
CLICK HERE TO GET FULL ACCESS TO 2002 Jaguar XKR BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Jaguar XKR AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Jaguar XKR cars and light trucks from 1990+.
Anti-lock Brakes -> System Service -> ABS/Traction Control Module (ABS/TCM) -> Brake System Bleed -> Component Replacement -> Fluid Intake Hose -> Front -> Hydraulic Control Unit (HCU) -> Lateral Acceleration & Rotation Sensors -> Rear -> S-Type -> Steering Wheel Rotation Sensor -> Wheel Speed Sensor -> X-Type -> XKR & XK8 -> Yaw Rate Sensor
Vehicle: 2002 Jaguar XKR 4.0 V8 GAS
Brake System Bleed
Bleeding the ABS system is not a routine maintenance operation and is only required when part of the system has been disconnected or the fluid is contaminated.
During the bleeding procedure, it is important that the level of fluid in the reservoir is maintained at approximately .0787 inch below the bottom of the filler neck. Motor/pump unit cannot charge accumulator if air and not fluid, is standing on low pressure side of pump.
If motor/pump unit, fluid intake hose or hydraulic unit of ABS system has been removed or disconnected, bleed as outlined in "Fluid Intake... "
CLICK HERE TO GET FULL ACCESS TO 2002 Jaguar XKR BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Jaguar XKR AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Jaguar XKR cars and light trucks from 1990+.
Hydraulic Brake Systems -> Brake System Bleed
Vehicle: 2002 Jaguar XKR 100 4.0 V8 GAS
- Raise and support vehicle.
- Start bleeding procedure at righthand rear wheel.
- Remove bleeder screw dust cap, then attach suitable one-way bleed valve and hose to bleed screw.
- Place hose end in suitable container, then loosen bleed screw 1/2 turn.
- Pump brake pedal until clear, air...
CLICK HERE TO GET FULL ACCESS TO 2002 Jaguar XKR BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Jaguar XKR AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Jaguar XKR cars and light trucks from 1990+.
Anti-lock Brakes -> Troubleshooting
Vehicle: 2002 Jaguar XKR 100 4.0 V8 GAS
Refer to F...
CLICK HERE TO GET FULL ACCESS TO 2002 Jaguar XKR BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Jaguar XKR AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Jaguar XKR cars and light trucks from 1990+.
Disc Brakes -> Rotor, Replace
Vehicle: 2002 Jaguar XKR 100 4.0 V8 GAS
- Remove brake caliper as outlined in "Caliper Service."
- On S-Type XJ8, XKR and XK8 models, remove mounting bolts, then the brake ...
CLICK HERE TO GET FULL ACCESS TO 2002 Jaguar XKR BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2002 Jaguar XKR AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2002 Jaguar XKR cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Front, Replace -> Rear, Replace -> S-Type & X-Type -> XKR & XK8
Vehicle: 2002 Jaguar XKR 100 4.0 V8 GAS
Front, Replace
S-Type & X-Type
- Raise and support vehicle, then remove tire and wheel assembly.
- Apply suitable brake pedal hold down tool and adjust pedal down approximately 1.6 inches.
- Install suitable bleeder bottle on nipple and loosen, then remove brake pipe from caliper.
- Remove guide pin mounting bolt and caliper.
- Reverse procedure to install. Bleed brake system as outlined under, "Hydraulic Brake Systems."
XKR & XK8
- Raise and support vehicle, then remove tire and wheel assembly.
- Remove caliper retaining spring and feed hose.
- Plug feed hose and caliper.
- Remove caps, guide pins and calipe...
CLICK HERE TO GET FULL ACCESS TO 2002 Jaguar XKR BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
![]() |
Access the Complete guide! |