Auto Parts Search
We have info for following modifications of 2007 Toyota Tundra
- 2007 Toyota Tundra 4.7 V8 GAS, CC:4663, CID:285, Fuel Injection, Aspiration:285
- 2007 Toyota Tundra 4.0 V6 GAS, CC:3956, Fuel Injection
- 2007 Toyota Tundra 5.7 V8 GAS, CC:5663, CID:345, Fuel Injection, Aspiration:345
- 2007 Toyota Tundra Limited 4.7 V8 GAS, CC:4663, CID:285, Fuel Injection, Aspiration:285
- 2007 Toyota Tundra Limited 5.7 V8 GAS, CC:5663, CID:345, Fuel Injection, Aspiration:345
- 2007 Toyota Tundra SR5 4.7 V8 GAS, CC:4663, CID:285, Fuel Injection, Aspiration:285
- 2007 Toyota Tundra SR5 4.0 V6 GAS, CC:3956, Fuel Injection
- 2007 Toyota Tundra SR5 5.7 V8 GAS, CC:5663, CID:345, Fuel Injection, Aspiration:345
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Toyota Tundra AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Toyota Tundra cars and light trucks sold in the U.S. from 1990+.
Toyota -> Automatic Transmission Oil Temperature Warning Lamp ->
Vehicle: 2007 Toyota Tundra Limited 4.7 V8 GAS
This lamp will be illuminated when automatic transmission or transfer case fluid temperature exceeds 302°F. If the lamp lights, allow vehicle to operate at idle speed until fluid temperature falls below 248°F; t...
CLICK HERE TO GET FULL ACCESS TO 2007 Toyota Tundra MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Toyota Tundra AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Toyota Tundra cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2007 Toyota Tundra Limited 5.7 V8 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 2007 Toyota Tundra MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Toyota Tundra AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Toyota Tundra cars and light trucks sold in the U.S. from 1990+.
Toyota -> Anti-Lock Brake System (ABS)/Vehicle Stability Control (VSC) System Warning Lamp -> 2000-09 Tundra
Vehicle: 2007 Toyota Tundra Limited 5.7 V8 GAS
The anti-lock warning lamp is used to warn of a system fault. The lamp will be lit during engine start-up, but should go out when the self-diagnostic system verifies proper anti-lock operation. If the lamp remains lit, a fault in the anti-lock brake system is indicated. After system diagnosis and repair are complete, the lamp can be reset using the following procedures:
- Place ignition switch ...
CLICK HERE TO GET FULL ACCESS TO 2007 Toyota Tundra MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Toyota Tundra AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Toyota Tundra cars and light trucks sold in the U.S. from 1990+.
Toyota -> Low Oil Level Warning Indicator ->
Vehicle: 2007 Toyota Tundra SR5 4.7 V8 GAS
This lamp lights to indicate that the engine oil level is below a specified level. The lamp will be illuminated during engine start-up. If...
CLICK HERE TO GET FULL ACCESS TO 2007 Toyota Tundra MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Toyota Tundra AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Toyota Tundra cars and light trucks sold in the U.S. from 1990+.
Toyota -> Air Bag Warning Lamp -> 2005-09 Tundra
Vehicle: 2007 Toyota Tundra SR5 4.0 V6 GAS
- Connect two service wires to terminals Tc and CG of data link connector.
- Turn ignition switch to On position and wait for approximately 6 seconds.
- SRS warning lamps will illuminate 2-4 seconds later. Within 1-5 seconds, ground terminal Tc of DLC.
- SRS warning lamp will go off within 2-4 seconds. Within 1-5 seconds, release...
CLICK HERE TO GET FULL ACCESS TO 2007 Toyota Tundra MAINTENANCE LAMP RESET PROCEDURES
MAINTENANCE LAMP RESET PROCEDURES FOR 2007 Toyota Tundra AUTOMOBILES
Maintenance lamp reset procedures with corresponding images for most domestic and imported 2007 Toyota Tundra cars and light trucks sold in the U.S. from 1990+.
Toyota -> Malfunction Indicator Lamp (MIL) ->
Vehicle: 2007 Toyota Tundra 4.0 V6 GAS
On some models equipped with OBD II, the MIL will also illuminate if the fuel tank filler cap is not properly tightened. Tighten fuel tank filler cap until it clicks.
The MIL should light when the ignition switch is placed in the On position without starting the engine. When the engine is started, the lamp should go out. If it remains lit, a fault has been detected by the diagnostic system and has logged a diagnostic trouble code. If the fault does not occur again within three trips, the lamp will go out but a diagnostic tro...
CLICK HERE TO GET FULL ACCESS TO 2007 Toyota Tundra MAINTENANCE LAMP RESET PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2007 Toyota Tundra vehicle. |
Access the Complete guide! |